Catálogos >
SMC >
SY - NEW

SY - NEW
1 / 164Páginas

Excertos do catálogo

5 Port Solenoid Valve New Increased Flow For The SY Series SY3000 10 mm width can drive a ø50 cylinder. SY5000 15 mm width can drive a ø63 cylinder. ∗Values based on comparison with the conventional SMC model. Refer to page 4 for common conditions. Thanks to the flow increase, valve size can be reduced. Energy and space savings. New ¡Added the EX260 Integrated-type (For Output) Serial Transmission System. ¡Added EtherNet/IP™ and EtherCAT to the EX600 Integrated-type (For Input/Output) Serial Transmission System (Fieldbus System). ¡Additional Options: Interface regulator assembly Individual SUP block assembly Individual EXH block assembly Dual flow fitting Name plate for manifolds Power Consumption With power saving circuit Power consumption is reduced by power saving circuit. Power consumption is decreased by approx. 1/3 by reducing the wattage required to hold the valve in an energized state. (Effective energizing time is over 67 ms at 24 VDC.) Refer to the electrical power waveform as shown on the right. [Electrical power waveform with power saving circuit] Applied voltage With power saving circuit Rubber seal Metal seal The value in ( ) are for the quick response and high pressure types. 70 million cycles (Rubber seal) 200 seal) cycles million (Metal ∗ According to SMC life test conditions

Abrir o catálogo na página 1

5 Port Solenoid Valve Plug-in connector connecting base [IP67Note)] b Connector type manifold Plug-in metal base [IP40] Connector type manifold 32 outputs Note) Refer to page 6 for details on IP67. Space saving / Improved operability Wiring, piping and operation are integrated on one side. Bottom ported is prepared. Space saving Bottom ported reduces the footprint. Multiple layer type is available as an option. This saves space in the lateral direction. Can be operated from the top. SUP stop valve spacer with residual pressure release valve Individual SUP/EXH spacer Direction, size and type...

Abrir o catálogo na página 2

Double check spacer with residual pressure release valve SUP stop valve spacer with residual pressure release valve Long time of intermediate stop and position holding are possible. [Intermediate stop] [Drop prevention] Air supply to each valve can be stopped individually. The valve and cylinder can be replaced without stopping other devices and equipment. Button for manual release of residual pressure Double check spacer assembly Double check spacer assembly Button for manual release of residual pressure To exhaust residual pressure on cylinder side. To exhaust residual pressure on...

Abrir o catálogo na página 3

Manifold Variations Wiring Common specification Connection Valve Series Top ported Bottom ported Side ported Top ported Bottom ported Side ported Plug-in Connector Connecting Base Plug-in Metal Base Negative common Positive common Circular connector Lead wire Flat ribbon cable D-sub connector Manifold Variations Serial transmission Type 10 Type 11 Type 12 Standard ć Option ̆ Made-to-Order (Refer to page 14.) bWiring Plug-in Metal Base Plug-in Connector Connecting Base D-sub connector Flat ribbon cable, PC wiring Serial transmission: D-sub connector Plug-in Connector Connecting Base Serial...

Abrir o catálogo na página 4

Mixed fitting sizes Exhaust throttle Reverse pressure Different pressures Elbow piping Straight piping Elbow piping Straight piping Straight piping Straight piping One-touch fittings Vacuum specification Valve Options Elbow piping SY3000/5000 mixed mounting Oil resistant (Other than designated turbine oil) Straight piping Individual SUP block assembly Individual EXH block assembly SUP/EXH blocking disk Label for blocking disk Back pressure check valve assembly Dual flow fitting Silencer (One-touch fitting connection type) Plug (White) Name plate Double check spacer with residual pressure...

Abrir o catálogo na página 5

Valve Specifications (Specifications, Response Time, Weight) Plug-in Metal Base Side ported Bottom ported Flat ribbon cable Type 50/Side Ported, Type 51/Bottom Ported, Type 52/Top Ported D-sub Connector, Flat Ribbon Cable, PC Wiring System [IP40] EX510 Gateway-type Serial Transmission System [IP20] Plug-in Connector Connecting Base Side ported Bottom ported Flat ribbon Lead wire Type 10/Side Ported, Type 11/Bottom Ported, Type 12/Top Ported EX600 Integrated-type (For Input/Output) Serial Transmission System (Fieldbus System) [IP67] EX250 Integrated-type (For Input/Output) Serial...

Abrir o catálogo na página 6

Plug-in Metal Base Applicable Main valve cylinder speed seal type Replacement Construction Specifications Parts Optimum Actuation Size Chart of Air Cylinder D-sub Connector Flat Ribbon Cable PC Wiring Circular Terminal D-sub Connector Plug-in Connector Lead Wire Flat Ribbon Cable Connector Block Box PC Wiring Connecting Base 300 mm/s or less SY3000 Metal seal 500 mm/s or less SY3000 Metal seal Specific Product Precautions Manifold Options One-touch Fittings and Plug Assembly/ Part No. [Common conditions] Pressure: 0.5 MPa Piping length: 1 m Load ratio: 50% Stroke: 200 mm Connector type...

Abrir o catálogo na página 7

Plug-in Metal Base Manifold Specifications D-sub connector Flat ribbon cable Serial wiring PH type 2 to 9 stations (J type: 2 to 8 stations) Manifold type Plug-in metal base SUP/EXH port type Common SUP/EXH Valve stations Flat ribbon cable connector with strain relief Conforming to MIL-C-83503 D-sub connector Conforming to MIL-C-24308 JIS-X-5101 Applicable connector Socket: 26 pins MIL type Socket: 10 pins MIL type Socket: 20 pins MIL type Positive common, Negative common Internal wiring Port size 1/4 M5 x 0.8, 1/8 ø2 One-touch fitting, ø3.2 One-touch fitting, ø4 One-touch fitting, ø6...

Abrir o catálogo na página 8

Plug-in Connector Connecting Base Terminal Circular Lead wire block box connector Flat ribbon cable Manifold type Plug-in connector connecting base D-sub connector Conforming to MIL-C-24308 JIS-X-5101 Applicable connector Flat ribbon cable connector with strain relief Conforming to MIL-C-83503 Socket: Socket: Socket: 10 pins 26 pins 20 pins MIL type MIL type MIL type Positive common, Negative common Internal wiring ø8 One-touch fitting ø5/16" One-touch fitting ø10 One-touch fitting ø3/8" One-touch fitting ø2 One-touch fitting, ø3.2 One-touch fitting, ø4 One-touch fitting, ø6 One-touch...

Abrir o catálogo na página 9