Catálogos >
PCI INSTRUMENTS LTD >
In Head Temperature Transmitter UP100

In Head Temperature Transmitter UP100
1 / 1Páginas

Excertos do catálogo

In Head Temperature Transmitter UP100 - 1

Data sheet Date Page IN HEAD TEMPERATURE TRANSMITTER UPLINK 100 ENVIRONMENTAL Ambient operating range: (-40 to +85) °C Ambient storage temperature: (-50 to +90) °C Ambient humidity range: 10 to 90% RH non condensing APPROVALS EMC - BS EN 61326 ANNEX A The UP100 is a cost effective “smart” transmitter that accepts resistance signals including RTD sensors and converts them to a standard industrial (4 to 20) mA transmission signal over a programmed range. In head transmitters can be applied in all areas of process automation. They make sure that the transmitted process temperature is both accurate and secure. It also means that the sensitive sensor cables no longer need to be connected to the control system. TECHNICAL CHARACTERISTICS Sensor Connection: 2 or 3 wire Screw terminal Minimum span: 25 °C Thermal Drift: 25 ppm / °C Excitation current: <200 uA Lead Resistance effect: 0.002 °C / Ohms Maximum lead Resistance: 20 Ohms per leg OUTPUT Output Type: 2 wire 4 to 20 mA current loop Output range: (4.0 to 20.0) mA Output Connection: Screw Terminal Output Limits: 3.8 to 21.5 mA Accuracy:(mA output /2000) or 5 uA (Whichever is the greater) Loop Voltage effect: 0.2 uA / V Thermal drift: 1 uA / °C Maximum output load: (Vsupply-10)/20] K Ohms (Example: 700 Ohms @ 24V) Note - Sensor input wires to be less than 3 metres to comply. Fitted inside a RDT terminal head IS Version HOW TO ORDER Please specify: model, range, options if any Example : UP100, -50 to 250 Deg C SIDE VIEW GENERAL SPECIFICATION Update time: 300mS Response Time: 400mS Start up time: 4 seconds ( I out < 4 mA during start up) Warm-up time: 1 minutes to full accuracy Power Supply: (8 to 30) Volts dc PHYSICAL Dimensions: 43 mm diameter; 21mm height Weight: 31 g (encapsulated) Electrical equipment for measurement control and laboratory use. Immunity test requirements for equipment intended for use in industrial locations Test configurations, operational conditions and performance criteria for transducers with integrated or remote signal conditioning. Electrostatic discharge EM Field Transient Burst (output) Surge (output) BASE VIEW Centre hole Ø4.0 mm _______________________________________________________________________________________________ PCI (Process System Solutions) Ltd, Unit 7 Slaidburn Crescent, Southport, Merseyside, PR9 9YF, UK, Tel: +44 (0) 1704 509090, Fax: +44 (0) 1704 509091, email: sales@pci-instruments.com, Website: www.pci-instruments.com (Specifications are subject to change without notice)

Abrir o catálogo na página 1