Catálogos >
Nidec Copal Electronics >
RMS20 - MANUAL SETTING TYPE MAGNETIC ENCODERS

RMS20 - MANUAL SETTING TYPE MAGNETIC ENCODERS
1 / 3Páginas

Excertos do catálogo

RMS20 - MANUAL SETTING TYPE MAGNETIC ENCODERS - 1

MANUAL SETTING TYPE MAGNETIC ENCODERS RoHS compliant High resolution of 256 P/R and fine setting Lower consumption of electric power (15 mA maximum) due to magnetic method 5 Long life for 10 times continuous run due to contactless & magnetic method Square wave output (with Amp.) Smooth rotation for setting RoHS compliant ■ PART NUMBER DESIGNATION Output connection 1：Cable wire Output phase ■ LIST OF PART NUMBERS Resolution Input voltage Part number ※Verify the above part numbers when placing orders. ■ STANDARD SPECIFICATIONS Electrical characteristics Mechanical characteristics Input voltage Input current Output wave form Shaft loading (When mounting) Resolution Phase difference of outputs A & B Maximum frequency response Rotational life Strength of tighten screw Square wave Output phases Output signal Rotational torque Magnetoresistive element Environmental characteristics Operating temp. range Storage temp. rang

Abrir o catálogo na página 1

RMS20 - MANUAL SETTING TYPE MAGNETIC ENCODERS - 2

MAGNETIC ENCODERS ■ RELIABILITY TEST The output shall satisfy the criteria below after the following tests. Test item Test conditions Amplitude : 1.52 mm or 98.1 m/s2 (10 G) whichever is smaller. 10 ~ 500 Hz excursion 15 min/cycle, 8 cycles each for X, Y, Z, directions. 3 times each in directions (X, Z) at 490 m/s2 (50 G), 11 ms. High temperature exposure 40 °C Relative humidity 90 ∼ 95 % 96 h (To be measured after wiping out moisture and leaving samples for 1 h at normal temperature and humidity after the test.) Thermal shock To be done 10 cycles with the following condition (To be...

Abrir o catálogo na página 2