Catálogos >
Manitowoc Cranes >
National Crane 600E2 Series

National Crane 600E2 Series
1 / 20Páginas

Excertos do catálogo

National Crane 600E2 Series Product Guide Features • 27,4 m (90 ft) foursection boom • 18,1 t (20 USt) rating • Self-lubricating Easy Glide wear pads • Internal anti-two

Abrir o catálogo na página 1

Features National Crane Series 600E2 •16,3 t (18 USt) maximum capacity • 36,9 m (121 ft) maximum vertical reach • 24,7 m (81 ft) maximum vertical hydraulic reach Four-section boom At 90 ft, the Series 600E2 four-section boom is the longest in its size range. The long boom allows the operator to perform more lifts without the use of a jib, reducing setup time and improving efficiency. Easy Glide boom wear pads Easy Glide boom wear pads reduce the conditions that cause boom chatter and vibration. The net result is smoother crane operation. The Series 600E2 comes equipped with A-frame...

Abrir o catálogo na página 2

* Product may be shown with optional equipment. Best in class performance and serviceability • The steel torsion box and flatbed further reduce frame flex • Speedy-reeve boom tip and sheave blocks simplify rigging changes by decreasing the time needed to change line reeving • Crane components painted before assembly reduce the chance of rust, improve serviceability and enhance the appearance of the crane • A control knob located on the swing motor brake release valve can be easily adjusted to the crane operator’s swing speed preference • Engine start/stop switches • Emergency stop overrides...

Abrir o catálogo na página 3

Mounting configurations Dimensions Accessories

Abrir o catálogo na página 4

Mounting configurations The configurations are based on the Series 600E2 with an 85% stability factor. The complete unit must be installed in accordance with factory requirements and a test performed to determine actual stability and counterweight requirements since individual truck chassis vary. Requires front SFO stabilizer to give machine full capacity 360˚ around the truck. Truck must meet the minimum requirements above. Front stabilizer gives the machine a solid base, helping the operator control loads precisely. Extended front frame rails required for SFO installation. Allows the...

Abrir o catálogo na página 5

Specifications Boom and jib combinations data Available in five basic models: Model 638E2 – Equipped with a 4,88 m - 11,58 m (16 ft - 38 ft) three-section boom. Maximum tip height is 14,63 m (48 ft) (no jib option available). 4,88 m - 11,58 m (16 ft - 38 ft) three-section boom Model 649E2 – Equipped with a 4,88 m - 15 m (16 ft - 49 ft) four-section boom. Maximum tip height is 17,98 m (59 ft). 4,88 m - 15 m (16 ft - 49 ft) four-section boom 6FJ29M 4,6 m - 7,6 m (15 ft - 25 ft) two-section jib Model 660E2 – Equipped with a 7,12 m - 18,3 m (24 ft - 60 ft) three-section boom. Maximum tip height...

Abrir o catálogo na página 6

Specifications 600E2 winch data • All winch pulls and speeds are shown on the fourth layer. Average breaking strength • Winch line pulls would increase on the first and second layers. • Winch line pulls may be limited by the winch capacity or the ANSI 5 to 1 cable safety factor, shown below this chart. • Hook blocks are rated at maximum capacity for the block. Do not exceed rated cable pull with any block. Cable supplied Standard planetary winch 9/16 in diameter rotation resistant Winch pull Winch speed Rope capacity Note: All ratings based on 128,7 LPM at 22,75 MPa (34 GPM at 3300 psi)...

Abrir o catálogo na página 7

Capacities Series 638E2: 11,58 m (38 ft) boom National Crane will send you a chart on request – or you may secure needed load rating information through your nearest National Crane dealer. CAUTION: • Do not operate crane booms, jib extensions, any accessories or loads within 3 m (10 ft) of live power lines or other conductors of electricity. • Jib and boom capacities shown are maximum for each section. • Do not exceed capacities at reduced radii • Load ratings shown on the load rating charts are maximum allowable loads with the outriggers properly extended on a firm, level surface and the...

Abrir o catálogo na página 8

Capacities Series 649E2: 15 m (49 ft) boom National Crane will send you a chart on request – or you may secure needed load rating information through your nearest National Crane dealer. BOOM LENGTH IN FEET CAUTION: • Do not operate crane booms, jib extensions, any accessories or loads within 3 m (10 ft) of live power lines or other conductors of electricity. • Jib and boom capacities shown are maximum for each section. • Do not exceed capacities at reduced radii • Load ratings shown on the load rating charts are maximum allowable loads with the outriggers properly extended on a firm,...

Abrir o catálogo na página 9

Capacities Series 660E2: 18,3 m (60 ft) boom National Crane will send you a chart on request – or you may secure needed load rating information through your nearest National Crane dealer. CAUTION: • Do not operate crane booms, jib extensions, any accessories or loads within 3 m (10 ft) of live power lines or other conductors of electricity. • Jib and boom capacities shown are maximum for each section. • Do not exceed capacities at reduced radii • Load ratings shown on the load rating charts are maximum allowable loads with the outriggers properly extended on a firm, level surface and the...

Abrir o catálogo na página 10

Capacities Series 671E2: 21,64 m (71 ft) boom National Crane will send you a chart on request – or you may secure needed load rating information through your nearest National Crane dealer. CAUTION: • Do not operate crane booms, jib extensions, any accessories or loads within 3 m (10 ft) of live power lines or other conductors of electricity. • Jib and boom capacities shown are maximum for each section. • Do not exceed capacities at reduced radii • Load ratings shown on the load rating charts are maximum allowable loads with the outriggers properly extended on a firm, level surface and the...

Abrir o catálogo na página 11

Capacities Series 671E2: 21,64 m (71 ft) boom with 13,72 m (45 ft) jib National Crane will send you a chart on request – or you may secure needed load rating information through your nearest National Crane dealer. CAUTION: • Do not operate crane booms, jib extensions, any accessories or loads within 3 m (10 ft) of live power lines or other conductors of electricity. • Jib and boom capacities shown are maximum for each section. • Do not exceed capacities at reduced radii • Load ratings shown on the load rating charts are maximum allowable loads with the outriggers properly extended on a...

Abrir o catálogo na página 12