data sheet flox[on] S
1 / 4Páginas

DATA SHEET flox[on]S I August 2020 I Page 1 Version 5.0 KB Proportional valve | Outlet flange with thread connection | Inlet flange with thread connection | M8 Power supply | M12 Connector signal interface Micro USB port | 3 LEDs operating mode backsight of flox[on] S economy and extended frontsight of flox[on] S stainless steel DiMENSiONS CONNECTION ASSIGNMENT Signals 4-20mA 5 USB PORT The USB Port connects the flox]on] B with a PC. M12ANALOG CONNECTOR Set Value Set Value Real value Real value Dig. Input All information is provided in best conscience. Some clients may desire certain modifications which lead to results other than those found in this manual.

DATA SHEET flox[on] S | August 2020 | Page 2 MASS FLOW CONTROLLER AVAILABLE MODIFICATIONS OF FLOX[ON] B The measurement of all flox[on] S mass flow controller is based on the principle of thermal anemometry. The measuring cell is located in a bypass. The measurement of the gas flow is temperature and pressure compensated. The regulation of the flow will be made by a pressure compensated proportional valve which is insensitive to incoming pressure (0-16 bar) as well as outflow pressure. The valve is controlled by a solenoid and can be opened fully under any pressure conditions. All flox[on]...

DATA SHEET flox[on] S | August 2020 | Page 3 MASS FLOW CONTROLLER You can get the software by asking for it (info@fc-technik.ch). It requires Windows. The software enables to operate the flox[on] B without any other process control. The software allows to: • to get all information about the device, • to see and to manipulate the calibration data, • to have a look at the actual operation and to overwrite the set point. Though the measuring cell does not require a recalibration for the rest of its lifetime it might be possible in very special processes to manipulate the calibration (here done...

DATA SHEET flox[on] S | August 2020 | Page 4 MASS FLOW CONTROLLER IMPORTANT NOTICES To ensure trouble-free operation, the flox[on] S should be installed in a horizontal position. If installed vertically, the device could produce faulty measurements under certain conditions. The flox[on] S is maintenance-free even under harsh conditions. In case of a fault or failure of the measuring cell, please contact the service center. When delivered, the flox[on] S comes in secure transport packaging. It can be stored under dry conditions for up to two years before installation. The flox[on] S is...