Catálogos >
Emerson Automation Solutions - ROSEMOUNT >
Lye Peeling of Fruits and Vegetables

Lye Peeling of Fruits and Vegetables
1 / 2Páginas

Excertos do catálogo

Lye Peeling of Fruits and Vegetables - 1

Food & Beverage Application Data Sheet Lye Peeling of Fruits and Vegetables Background Many fruits and vegetables are prepared for peeling and canning by exposure to caustic (NaOH). To ensure adequate and consistent peeling, the concentration of caustic in the treatment bath must be maintained at an effective strength. At the same time, if the caustic bath is too strong the fruit or vegetable can be damaged. Process The typical process consists of an open tank of caustic heated to 170–220 °F (76–105 °C) by live steam. The target caustic concentration can vary from 3 to 15 %. Exposure time for the product is usually 5 minutes or less, after which the product is placed on moving grates and washed by high pressure nozzles to remove entrained caustic. A significant amount of caustic is carried out by the product, so the bath must be continually replenished to maintain an adequate volume of caustic solution and a caustic concentration at the target value. This could involve addition of water, based on level control, as well as makeup caustic, based on the conductivity measurement. The best place to start is to look at how the bath behaves and how concentration is maintained manually. Since the background increase cannot be distinguished from the conductivity due to the caustic, the conductivity set point (or calibration curve for a concentration measurement) may need to change as the bath ages. This effect will be smaller for higher caustic concentrations and for shorter intervals between bath replacement. Concentration Measurement In general, when there is background conductivity, the conductivity versus concentration curve will not be the same as the standard curve for caustic (NaOH) in distilled water, due to buildup of salts in the bath. The curve must be developed from operating data, i.e. conductivity and titrated caustic concentrations. Data should be taken over the life of at least three (3) baths; the age of the bath and any additions to the bath should be noted, in addition to the conductivity and titrated caustic concentration. Once a curve has been developed, the on-line measurement can usually be corrected for salt build-up by standardization following a routine laboratory titration. Important Considerations The Measurement Due to its resistance to fouling, toroidal conductivity is the best measurement technique here. The conductivity sensor is typically mounted in the holding tank (Figure 1). Relatively clean processes may use the 228 sensor, but applications with potential for heavy coating should use the large bore 226 sensor. As the bath ages, there is a buildup of salts, which are leached out of the peels and carried in with dirt and other suspended contaminants. This buildup causes an increase in the background conductivity. Select the toroidal conductivity sensor based on how heavily the bath is loaded with suspended solids. When evaluating how to control bath concentration and volume, how the bath behaves and how it is manually controlled should be thoroughly examined. When setting up a concentration measurement, data should be taken over the life of three (3) baths to determine the relationship between conductivity and concentration.

Abrir o catálogo na página 1

Lye Peeling of Fruits and Vegetables - 2

Food & Beverages Instrumentation 226 and 228 Toroidal Conductivity Sensors 1066 Toroidal Conductivity Analyzer Toroidal (inductive) principle of measurement and construction Chemically-resistant materials of construction 4–20 mA output with superimposed HART® or FOUNDATION™ Fieldbus communications protocol Clear, Large, easy-to-read display Customizable percent concentration curve Automatic/manual temperature compensation ensures accurate monitoring and control Figure 1 - Lye Peeling of Fruits and Vegetables Fruit or Vegetables Washers Holding Tank www.RosemountAnalytical.com...

Abrir o catálogo na página 2