Catálogos >
Arconic >
Camloc Catalogue Keenserts

Camloc Catalogue Keenserts
1 / 9Páginas

Adicionar aos Favoritos

Excertos do catálogo

Traditionally Innovative Fastening ALCDA

Abrir o catálogo na página 1

Alcoa Fastening Systems

Abrir o catálogo na página 2

Traditionally Innovative General Information The Camloc brand was established in 1937. Since that time our fastening systems have been successfully integrated into numerous applications within many different industries. Each of our customers will feel the full benefit of our 70 years of fastening experience. Customer proximity, environmental awareness and quality are the main criteria of our services QUALITY MANAGEMENT SYSTEM ISO/TS 16949:2002 Also* FatWnldgfi f elrchUd Faalenars Euro pa-Cam toe *f BMM a aiaatyMMnagefnertSyuam HWPCWMi vMHtmroqutammii of tSOSTS 16949 X0? fat Uto...

Abrir o catálogo na página 3

Important Information Traditionally Innovative Threaded Inserts KEENSERTS? are high strength threaded inserts made from stainless steel 1.4305. They are pas- sivated according to EN 2516. Our KEENSERTS?standard product range contains metric thread dimensions. Imperial dimensions and specials are available upon request. KEENSERTS* may be used in alloys, light materials, steel and cast iron to increase the strength of the thread in these materials. They can also be used for thread repair, whereas the defect thread can be replaced with the same nominal diameter. KEENSERTS* have less attrition....

Abrir o catálogo na página 4

General Installation Instructions - with standard drill - with cone countersink (80° - 100°) - by hand or with installation tool (see instalation data pages B-1 to B-4) - installation of the kees with installation tool and hammer (see picture) or press Installation depth of the insert is dened by the pre-assembled kees. The thread depth of the is based on the depth of the countersink. Key Slot Pre-Broaching: For very hard materials with a hardness greater than 30 HRC or 300 Vickers a broaching tool for pre-broaching is necessary. Threaded inserts, installation as described but before...

Abrir o catálogo na página 5

KNCM Series Type “S“ Type “L“ 2 pieces up to internal thread M6 4 pieces internal thread M8 and up Internal thread locking Part-no. Standard type “S“ Dimensions Locking type “L“ Removal dimensions Drill Hand installation tool part-no. Alcoa Fastening Systems

Abrir o catálogo na página 6

2 pieces up to internal thread M6 4 pieces internal thread M8 and up internal thread locking Part-no. Standard type “S“ Dimensions Locking type “L“ Removal dimensions Drill Hand installation tool part-no. Alcoa Fastening Systems

Abrir o catálogo na página 7

KNHM Series Type “S“ 2 pieces up to internal thread M6 4 pieces internal thread M8 and up Internal thread locking Part-no. Standard type “S“ Dimensions Locking type “L“ Removal dimensions Drill Hand installation tool part-no. Alcoa Fastening Systems

Abrir o catálogo na página 8