Catálogos >
4B Braime Components >
M800 Speedswitch - underspeed motion monitor

M800 Speedswitch - underspeed motion monitor
1 / 2Páginas

Excertos do catálogo

M800 Speedswitch - underspeed motion monitor - 1

Product Information M800 Elite Speed Switch M800 Elite Speed Switch Monitors Rotating Machinery for Dangerous Underspeed Conditions APPLICATION The M800 Elite Speed Switch is designed to detect belt slip, belt underspeed, stop motion, low speed or zero speed on bucket elevators, conveyors, airlocks, mixers, fans, grinders and many other rotating machines. Totally sealed and simple to calibrate, the M800 Elite works in the harshest of conditions. METHOD OF OPERATION An inductive sensing device located in the nose of the M800 Elite enclosure will detect a metal target. This target can be an existing bolt head or device attached to a shaft. During installation the M800 Elite is set to the normal machine shaft RPM by calibrating with the magnet provided. The internal microprocessor sets the alarm and shutdown relays. Two M800 Elite models are available: Model M8001V10C may be used either as a dual trip unit with an alarm at 10% below set speed and a shutdown signal at 20% below set speed, or a single trip giving a shutdown signal at 20%. Model M8002V10C may be used either as a dual trip unit with an alarm at 5% below set speed and a shutdown signal at 10% below set speed, or a single trip giving a shutdown signal at 10%. A simple calibration facility allows either model to be programmed to give a start up delay of up to 15 seconds, while simultaneously calibrating for normal running speed. If required, the M800 Elite has an additional pulsed output, which can be connected to display actual shaft RPM on a PLC or speed display. FEATURES ► Universal Voltage (24 – 240 VAC/VDC) ► Dual Set-Points for Alarm and Shutdown ► Totally Sealed Construction: Submersible ► Microprocessor Accuracy & LED Indicators ► Built In Conduit Adaptor (1/2” NPT) ► CSA Class II, Div. 1 Groups E, F & G Approved ► IP67 Protection M800 Elite Installed on Shaft with Whirligig® PART NUMBERS/ACCESSORIES ► M8001V10C M800 Elite (10% and 20% Relays) ► M8002V10C M800 Elite (5% and 10% Relays) ► SM1 SpeedMaster™ ► WG4A-BR Whirligig® Shaft Sensor Mount ► MAG2000M Mag-Con™ Magnetic Connector ► TACH3V5 Tacho Speed Display Whirligig® with Optional Mag-Con™ Connector Tacho Speed Display Detailed specification, wiring diagrams and installation/operating instructions available upon request. Whirligig®: U.S. Pat # 6,109,120 Mag-Con™: U.S. Pat # 6,964,209 Please refer to instruction manual for correct installation. Information subject to change or correction. Jan 2015

Abrir o catálogo na página 1

M800 Speedswitch - underspeed motion monitor - 2

Product Information M800 Elite Speed Switch CONNECTIONS Black Alarm Relay Orange Shutdown Relay Tacho Output The diagram shows the state of the internal contacts with power applied. See installation manual for wiring procedure. The unit can be used with or without the tacho output. The SpeedMaster™ is the only device that accurately tests the calibration of a speed switch, and allows testing of the alarm and shutdown features of the sensor while installed on the machine shaft. 1/2” NPT Threaded Conduit Entry 2m Cable 8 x 20 AWG Overall Diameter 8.3 mm TECHNICAL SPECIFICATIONS M8001V10C and...

Abrir o catálogo na página 2