Catálogos >
4B Braime Components >
4B Binswitch - Capacitance Point Level Switch

4B Binswitch - Capacitance Point Level Switch
1 / 2Páginas

Excertos do catálogo

4B Binswitch - Capacitance Point Level Switch - 1

Capacitive Proximity Sensor APPLICATION Detects level or plug situations in bulk granular solids or liquids. Can also be used for misalignment monitoring on a conveyor or elevator. METHOD OF OPERATION The Binswitch Sensor detects level or plug situations for bulk granular solids or liquids in tanks, bins, or silos and can be used as a plug or choke detector in chutes, conveyors and elevator legs. Programmable features include time delay on material arriving or leaving, and failsafe relay settings for high and low levels. A two colour LED shows material present or absent and flashes red or green to show the time delay is operating. The programmable sensor operates on 12-240 VAC/DC and gives a changeover relay contact output. The polycarbonate housing is corrosion and abrasion resistant, dust-tight, and waterproof. Product Information FEATURES t Universal Voltage ■■ Adjustable Sensitivity ■■ 25mm detection range ► Certified to ATEX & lECExClass 2 Division 1 Groups E, F & G Approved k IP65 Protection: Totally Sealed Construction PART NUMBERS/ACCESSORIES ■■ BS12V10AI 2-Wire Binswitch High Level Fail Safe ► BS15V10AI 5-Wire Binswitch High Level Fail Safe k- BS22V10AI 2-Wire Binswitch Low Level Fail Safe k- BS25V10AI 5-Wire Binswitch Low Level Fail Safe k- BAS2 Binswitch Abrasion Shield k- BTAS1 Teflon Abrasion Shield End Cap k TMP Top Mounting Plate k- SMP Side Mounting Plate k- BMPA 1-1/4” NPT Mount Plate Adaptor k- BAS Polyurethane Abrasion Shield 1-1/4" NPT k- KIT CAPA Adjustable level from 0,65 to 2,05 meters BAS2 Abrasion Shield Please refer to instruction manual for correct installation. Information subject to change or correction. September 2011

Abrir o catálogo na página 1

4B Binswitch - Capacitance Point Level Switch - 2

Product Information TECHNICAL SPECIFICATIONS Type Power Supply Approvals Contact Max. Frequency Protection Sensitivity Volt drop Cable Calibration Capacity Ambiant Temperature 24-240 Vac/dc 12-240 Vdc 24-240 Vac ATEX EX II 1D T100°C (Zone 20) IECEx Zone 20 & CSA Normally Closed Normally Open Normally Closed Normally Open 4 Hz IP 65 Detects up to 25 mm 8 V max. 2 wires, 5m or 10m cable 5 wires, 5m or 10m cable Turn sensitivity adjustment screw; the silo must be empty for calibration 200 mA Max. Changeover relay rated at 3A 240Vac. Non inductive -15° to + 50°C Black/orange Relay output 3A...

Abrir o catálogo na página 2