Zw/ck / Roell Materials Testing Product Information Mflow Extrusion Plastometer Applicational range The Mflow is a modular, expandable device with which you can determine the melt mass and melt volume flow rate. Affordable to setup and gradually expand at any You can optionally expand the Mflow with, for example, the pneumatic weight lifting unit or the weight pegging unit. The extrusion plastometers are equipped with heating elements that are specially adapted to the thermal conditions of extrusion barrel and device covers. This achieves a very good distribution of temperature over space and time. Operation of the Mflow via a PC offers all the can be operated, the traceability of the results and their further processing with testXperf6 II LIMS is possible for a statistical check and as long-term statistics. • The automatic parameter control (APC) minimizes the measurement errors and optimizes the test • The weight selector allows you to change the test weights quickly and easily. The piston is also held is any pre-heating position required • A travel transducer is available for determination of the • testXperf6 II works for you - whether through multi- device operation or with testXperf6 II LIMS

Zw/ck / Roell Materials Testing Product Information Mflow Extrusion Plastometer Basic Instruments Mflow Extrusion Plastometer, supply-voltage 220 to 240 V, 50/60 Hz Mflow Extrusion Plastometer, supply-voltage 100 to 127 V, 50/60 Hz Item number Technical data for Mflow Extrusion Plastometer The Mflow Extrusion Plastometer in its basic version is equipped for MFR testing to Method A and can be expan- ded for MVR testing to Method B. Tests according to the following Standards are possible: Methods A and B to Technical data of the instruments Power consumption Dimensions: height x width x depth Number...

Zw/ck # Roell Materials Testing Product Information Mflow Extrusion Plastometer Extrusion barrels An extrusion barrel must be selected depending on the material that is to be tested. Cleaning pads and a cleaning piston are supplied to clean the extrusion barrel. Description Item number Extrusion barrel for fluorine-free plastics, inner dia. 9.55 mm, accurately machined hole, wear-resistant 001331 Extrusion barrel for fluorine-containing plastics, inner dia. 9.55 mm, accurately machined hole 001345 At least one piston must be selected depending on the materials that are to be tested. If testing...

Zw/ck / Roell Materials Testing Product Information Mflow Extrusion Plastometer Pneumatic weight lifting unit and test weights The Mflow can be fitted with test weights depending on the type of plastics that is to be tested. For reduced workload, a pneumatic weight lifting unit can be added to lift and lower the weights without using muscle power. The weight-lifting unit allows the test weight to be raised automatically when the pre-heating position is reached, minimizing premature outflow of the plastic granulate during the pre-heating period. When using test weights with test loads e.g. 2.16...