Extruder Measuring Equipment A Hogogroup Company Autozero Melt Pressure Sensor PTED/PTER/PTED Series Remotely autozero by shorting two pins together Several amplified signal output are optional ISO9001-2015 Shanghai Sensoriot Technology Co.,Ltd.

Extruder Measuring Equipment A Hogogroup Company Autozero Melt Pressure Sensor Content 1. Introduction 2. Application 3. Product Featuress 4. Technical data 5. Dimensions 6. Electrical connection and debugging 7. Ordering Guide 8. Installation and Removal 9. Sensors cleaning 10. Transport and Storage 1. Introduction PTED/PTER/PTES series adopt imported stainless steel materials, core elements and digital mode circuit design. Realizing sensor linear compensation through digital program. Remote autozero via shorting two pins together. Comply with SIL2, CE safety performance standards. High precision,...

Extruder Measuring Equipment A Hogogroup Company Autozero Melt Pressure Sensor 02 Shanghai Sensoriot Technology Co.,Ltd.

Extruder Measuring Equipment A Hogogroup Company Autozero Melt Pressure Sensor 03 Shanghai Sensoriot Technology Co.,Ltd.

Extruder Measuring Equipment A Hogogroup Company Autozero Melt Pressure Sensor 6. Electrical connection & Debugging After the pressure sensor has been installed on the pipeline, the electrical connection must be made in accordance with the connection method shown in the wiring diagram below. The PTED/PTER/PTES pressure sensor is equipped with an integrated amplifier circuit. The calibration process must be carried out when the pipeline is heated and the pressure is zero. The zero point is adjusted by activating the autozero function,which is started via shorting two pins together. Start by connecting...

Extruder Measuring Equipment A Hogogroup Company Autozero Melt Pressure Sensor It must be a shielded cable, each core wire is about 0.3mm2, the heat-resistant temperature is not less than 105℃, each core wire connection terminal should be insulated and protected by heat shrinkable tube, the shielding wire should be connected with the plug-in metal, and the cable should be specially welded carefully, otherwise it may cause signal transmission errors or damage the product. It is recommended to use a dedicated cable that has been soldered by Ziasiot. For extra wires in the cable, each wire needs...

Extruder Measuring Equipment A Hogogroup Company Autozero Melt Pressure Sensor 06 Shanghai Sensoriot Technology Co.,Ltd.

Extruder Measuring Equipment A Hogogroup Company Autozero Melt Pressure Sensor 8. Installation & Removal Installation When installing the pressure sensor, the sensor hole should be within the size requirement marked in following drawing and the assembly accuracy can be checked by testing bolts. Before installing the sensor , first clean the impurities in the hole and between the threads, then the thread of the sensor is coated with heat-resistant slurry, the screw teeth can be avoided . The installation force is very important, the installation torque of the sensor can only act on the shaft (hexagon),...

Extruder Measuring Equipment A Hogogroup Company Autozero Melt Pressure Sensor Removal The removal of sensor must be done under heated conditions (plastic melting point). When remove the sensor, please note that the diaphragm has no contact pressure. The force to remove the sensor must only be applied on the shaft (hexagon), and do not apply any force to the head of the sensor. 9. Sensors cleaning In order to clean the diaphragm, the sealing surface and thread of the sensor must have the same temperature as the melting point of the plastic. Both the diaphragm and the sealing surface can be wiped...