Extruder Measuring Equipment A Hogogroup Company Standard Melt Pressure Sensor PT112B/PT123B/PT133B Series One key to reset zero 4-20mA / 0-10V/0-5V Output ISO9001-2015 Shanghai Sensoriot Technology Co.,Ltd.

Extruder Measuring Equipment A Hogogroup Company Standard Melt Pressure Sensor Content 1.Introduction 2.Application 3.Product features 4.Technical data 5.Dimensions 6.Electrical connection and debugging 7.Ordering Guide 8.Installation and Removal 9.Sensors cleaning 10.Transport and storage 1. Introduction PT112B/PT123B/PT133B melt pressure transmitter is a kind of accurate measuring equipment, which adopts high performance core element, digital-analog integrated circuit design, realizes linear compensation through program, and can obtain 0.5% FSO measurement accuracy. 2. Application This series...

Extruder Measuring Equipment A Hogogroup Company Standard Melt Pressure Sensor 02 Shanghai Sensoriot Technology Co.,Ltd.

Extruder Measuring Equipment A Hogogroup Company Standard Melt Pressure Sensor 03 Shanghai Sensoriot Technology Co.,Ltd.

Extruder Measuring Equipment A Hogogroup Company Standard Melt Pressure Sensor 6. Electrical connection & Debugging After the pressure transmitter has been installed on the pipeline, the electrical connection must be carried out in accordance with the connection the wiring diagram below. PT112B/PT123B/PT133B series pressure transmitter is equipped with an integrated amplifier circuit. The calibration process must be that the pipeline is heated and the pressure is zero. The zero point is adjusted by twisting the "Z" position screw" at the top of the shell with an object similar to a toothpick....

Extruder Measuring Equipment A Hogogroup Company Standard Melt Pressure Sensor The cable shall be covered with shielding layer cable, each core wire is about 0.3 mm2, temperature-resistance is not less than 105℃, each core wire connection column shall be insulated and protected by heat shrink tube isolation, shield wire shall be connected with plug-in metal, cable welding should be particularly careful, otherwise it may lead to signal transmission error or damage products, It is recommended to use Ziasiot welded special cable. For excess lines in the cable, each wire should be wrapped separately...

Extruder Measuring Equipment A Hogogroup Company Standard Melt Pressure Sensor 06 Shanghai Sensoriot Technology Co.,Ltd.

Extruder Measuring Equipment A Hogogroup Company Standard Melt Pressure Sensor 8. Installation & Removal Installation When installing the pressure transmitter, it must be noted that the transmitter hole is within the size requirement range indicated in the following drawings. The assembly accuracy can be checked by testing bolts. the figure "a" is the correct installation position, the figure" b" and "c" are the wrong installation position. Before installing the transmitter, first clean the impurities in the hole and between the thread teeth, then apply the heat resistant slurry on the transmitter...

Extruder Measuring Equipment A Hogogroup Company Standard Melt Pressure Sensor Removal The removal of the pressure sensor must be done under heating conditions (plastic melting point). When removing the sensor, please note that the diaphragm has no contact pressure. the force to unload the sensor must be applied only on the shaft (hexagon) and do not apply any force to the sensor head. 9. Sensors cleaning In order to clean the diaphragm, the sealing surface and thread of the transmitter must have the same temperature as the melting point of the plastic. The diaphragm and sealing surface can be...