- Catalogs
- Zhuhai Chenhui Technology Co., LTD.
- MPD 025 Gear Pump
MPD 025 Gear Pump
MPD 025 Gear Pump
- Flow Rate: 0-2.5L/min (0.65ml/rev)
- Viscosity Range: 0~3000cps
- Temperature Range: -10℃~100℃
- Pressure: 5Bar
- Motor Power Options: 30W to 1000W
- Noise Level: <60dB at 4000rpm
- Speed: 0~4500rpm
- Pump Body: 304L or 316L
- Gear Shaft: PEEK Gear with 316L or Ceramic Shaft
- Ports: G1/8 or G1/4
- Precise transmission without pulsation
- Strong vacuum suction capacity
- No leakage due to magnetic drive and static O-ring seal
- Install thread joints and wrap with raw material belt to prevent leakage.
- Position pump close to the liquid source and ensure pipe size matches pump body joint size.
- Follow the directional arrow on the end cover for installation.
- Ensure liquid presence in the pump body to avoid damage.
- Flush pump pipe before first use and install a filter on the inlet pipe.
- Cool the pump during continuous operation.
Catalog excerpts
— A:BLDC Motor B:Brush Motor C:Stepper Motor D:Servo Motor GeerShaft —^ Pump Body E:Three-Phase Motor A:PEEK Gear+316L Shaft B:PEEK Gear+Ceramic Shaft 1. Precise transmission without pulsation, through the gear to provide continuous accurate fluid delivery. 2. Strong vacuum suction capacity, high and stable conveying pressure, can achieve high pressure conveying of low viscosity liquid. 3. No leakage, magnetic drive and static O-ring seal can ensure that the medium in the pump is isolated from the outside world, to achieve no leakage.
Open the catalog to page 1
Exploded View
Open the catalog to page 2
MPD 025 Gear Pump Equipped With Brushed Motor u Brushed DC motor, easy to control, high speed for high efficiency liquid delivery, super cost effective Wiring Instructions
Open the catalog to page 3
Installation and use instructions 1. Take out the inlet and outlet plug and install the matching thread joint. Pump inlet and outlet joints must be wrapped with raw material belt, especially at the inlet, such as leakage will have no suction. 2. pump as close to the liquid source as possible, the inlet and outlet pipe size can not be less than the pump body joint size, as far as possible to shorten the length of the pipe, if the pipe is very long, please increase the diameter of the pipe. 3. Install in accordance with the direction indicated by the arrow on the end cover, otherwise the liquid...
Open the catalog to page 4
