• Precise transmission without pulsation, ensuring continuous and accurate fluid delivery.
• Strong vacuum suction capacity and stable conveying pressure for high-pressure delivery of low viscosity liquids.
• No leakage due to magnetic drive and static O-ring seal, isolating the medium from the external environment.

• Flow rate: 5ml-250ml/min (0.35ml/rev).
• Materials: 304L and 316L stainless steel, PEEK gears with 316L or ceramic shafts.
• Inlet and outlet threads: G1/8 or G1/4.
• Motor types: DC BLDC, DC Brush, Stepper, Servo, and three-phase AC motors.
• Power options range from 30W to 1000W.
• Viscosity range: 0~3000cps.
• Temperature range: -30℃ to 110℃.
• Max pressure: 20 Bar.
• Compatible with almost all liquids except strong acids and bases.
• Inlet filter: 400 mesh.
• Inlet vacuum level: -0.85 Bar.
• Noise level: <60dB.
• Working speed: 0~800rpm.

The micro magnetic drive gear pump is widely used in fields such as food and beverage, cosmetics, mechanical coding, life sciences, and chemical measurement, becoming a core component of industrial equipment.

1. Install the matching thread joint after removing the inlet and outlet plug. Ensure joints are wrapped with raw material belt to prevent leakage.
2. Position the pump close to the liquid source, ensuring pipe sizes are not smaller than the pump body joint size. Shorten pipe length or increase diameter if necessary.
3. Install according to the direction indicated by the arrow on the end cover to ensure proper liquid absorption.
4. Ensure liquid is present in the pump body to avoid permanent damage from dry transfer.
5. Flush the pump pipe before first use and install a filter on the inlet pipe to ensure particle diameter in the liquid is less than 20 microns.
6. Cool the pump in time during continuous operation.