MPB015 Magnetic Driver Gear Pump DESCRIPTIOr Model: MPB 015 B A A A H B:Brush Motor C:Stepper Motor D:Servo Motor E:Three-Phase Motor Gear/Shaft Material Pump Body Materia A:PEEK Gear+316L Shaft B:PEEK Gear+Ceramic Shaft 1. Precise transmission without pulsation, through the gear to provide continuous accurate fluid delivery. 2. Strong vacuum suction capacity, high and stable conveying pressure, can achieve high pressure conveying of low viscosity liquid. 3. No leakage, magnetic drive and static O-ring seal can ensure that the medium in the pump is isolated from the outside world, to achieve no leakage.

hexrockeh screws Front end cover / tinql f Dowel | Drwing gear; chamber| Shaftsleevi Internal magnetic I steel / Countersunk head screw M3x*

MPB015 Magnetic Driver Gear Pump l!.!£L&©Equipped With BLDC Motor ♦ With DC brushless motor, stable operation, with the controller can achieve accurate control, long service life. Potentiometer seven-wire speed regulation 3. Yellow Thin Wire: Speed Regulation (+5V) 4. Brown Thin Wire: Potentiometer Speed Regulation 5. Green Thin Wire: Speed Regulation GND 6. Blue Thin Wire: Speed signal output 7. White Thin Wire: Direction control (Pump reverses when connected to green line) 1.5L Gear Pump Flow-PressureCurve(medium:water,temp:room temp)

Installation and use instructions 1. Take out the inlet and outlet plug and install the matching thread joint. Pump inlet and outlet joints must be wrapped with raw material belt, especially at the inlet, such as leakage will have no suction. 2. pump as close to the liquid source as possible, the inlet and outlet pipe size can not be less than the pump body joint size, as far as possible to shorten the length of the pipe, if the pipe is very long, please increase the diameter of the pipe. 3. Install in accordance with the direction indicated by the arrow on the end cover, otherwise the 4. please...