Vehicle-Mounted Fuel Gas Leakage Detection Module （Model:ZP05） Zhengzhou Winsen Electronics Technology Co.

Statement This manual copyright belongs to Zhengzhou Winsen Electronics Technology Co., LTD. Without the written permission, any part of this manual shall not be copied, translated, stored in database or retrieval system, also can’t spread through electronic, copying, record ways. Thanks for purchasing our product. In order to let customers use it better and reduce the faults caused by misuse, please read the manual carefully and operate it correctly in accordance with the instructions. If users disobey the terms or remove, disassemble, change the components inside of the sensor, we shall not...

Zhengzhou Winsen Electronics Technology Co., Ltd ZP05 Vehicle-Mounted Fuel Gas Leakage Detection Module Profile ZP05 adopts thick film semiconductor sensor, which is designed for vehicle-mounted fuel gas leak alarm. It has the basic functions of vehicle-mounted flue gas leak alarm: electric power light, fault lamp, alarm light, output signal of working state; It can be installed respectively in the different positions of the vehicle, reducing the development period and guaranteeing high accurate detection. Features High sensitivity, wide voltage input, strong anti-jamming capability, good stability...

Zhengzhou Winsen Electronics Technology Co., Ltd Pins Definition Vcc（DC 9V -32V） 5V output GND alarm lamp fault lamp State output S Power lamp Reserved Application Diagram Alarm lamp Fault lamp Output S Power lamp Fig2 Application Diagram S is the state output for the module: In normal working state: S is high level In failure state: S is low level In alarm state: Output is 1Hz wave which occupies 50% ratio Other vacant pins can be customized according to customers’ actual request, such as the output signal of buzzer, relay, solenoid valve &etc. Cautions 1 .Following conditions must be prohibited...

Zhengzhou Winsen Electronics Technology Co., Ltd must avoid exposing to silicon bond, fixature, silicon latex, putty or plastic contain silicon environment. 1.2 High Corrosive gas If the module is exposed to high concentration corrosive gas (such as H2S, SOX, Cl2, HCl etc.), it will not only result in corrosion of sensor’s heating material and pins, also it causes sensitivity and performance attenuation. 1.3 Touch water Sensitivity of the sensors will be reduced when spattered or dipped in water. 1.4 Freezing Do avoid icing on sensor’s surface, otherwise sensing material will be broken and lost...