Electrochemical Ozone Detection Module （Model：ZE25A-O3） User’s Manual Version: 1.0 Valid from: 2021.04.01 Zhengzhou Winsen Electronics Technology Co.

Statement This manual’s copyright belongs to Zhengzhou Winsen Electronics Technology Co., LTD. Without the written permission, any part of this manual shall not be copied, translated, stored in database or retrieval system, also can’t spread through electronic, copying, record ways. Thanks for purchasing our product. To make you use our sensors better and reduce the faults caused by misuse, please read the manual carefully and operate it correctly in accordance with the instructions. If users disobey the terms or remove, disassemble, change the components inside of the sensor, we shall not be...

Zhengzhou Winsen Electronics Technology Co.,Ltd Electrochemical Ozone Detection Module ZE25A-O3 Product Description ZE25-O3 is a general-purpose and miniaturization electrochemical Ozone detection module. It utilizes electrochemical principle to detect ozone in air which makes the module with high selectivity and stability. It is a combination of mature electrochemical detection principle and sophisticated circuit design. Features *High sensitivity & resolution& low power consumption& long lifespan *UART Output *Good stability, good anti-interference *Excellent linearity Application Portable...

Zhengzhou Winsen Electronics Technology Co.,Ltd UART (RXD) 0~3.0V Data input UART (TXD) 0~3.0V Data output Communication Protocol 1 General Settings Table 3 Baud Rate Data Byte Stop Byte check bits 2 Communication Commands There are two communication type: active upload type and Question & Answer type. The default type for this module is active upload and it sends gas concentration every other second. If it is Q&A mode and you want to switch it to active upload mode again, please send following command: Command to switch Q&A mode to active upload mode: Start Byte Data of active upload show as...

Zhengzhou Winsen Electronics Technology Co.,Ltd Command to turn off active upload mode: Start Byte Switch command Read concentration under Q&A mode: Start Byte Return gas concentration as follow: Byte0 High Byte(ppb) NOTE: Gas concentration(PPB)=(Concentration high byte*256+Concentration low byte). If users would like to change the unit into PPM: PPM=PPB/1000. 3 Checksum calculation method Checksum = (Negative (Byte1+Byte2+Byte3+Byte4+Byte5+Byte6+Byte7)) +1 unsigned char FucCheckSum(unsigned char *i,unsigned char ln) { unsigned char j,tempq=0; i+=1; for(j=0;j<(ln-2);j++) { tempq+=*i; i++; } tempq=(~tempq)+1;...

Zhengzhou Winsen Electronics Technology Co.,Ltd Cautions 1.Prohibit plug and pull the sensor on the module. 2. Prohibit change and shift the installation of electronic components. 3. Please do not use the modules in strong air convection environment. 4.The module should not withstand excessive shock or vibration. 5. The module needs to be warmed up for 5 hours at the first power-on. 6.Do not use this module for systems involving personal safety. 7.Please do not use the modules in strong air convection environment. 8.Do not place the module in high-concentration organic gas for a long time. Long-term...

Zhengzhou Winsen Electronics Technology Co.,Ltd Email: [email protected] Leading gas sensing solutions supplier in China!