Zhengzhou Winsen Electronics Technology Co., Ltd Carbon Monoxide Module （Model No.：ZE16B-CO） Zhengzhou Winsen Electronics Technology Co., Ltd. Tel: 86-371-67169097 67169670 Email: [email protected] Leading gas sensing solutions supplier in

Zhengzhou Winsen Electronics Technology Co., Ltd Statement This manual’s copyright belongs to Zhengzhou Winsen Electronics Technology Co., LTD. Without the written permission, any part of this manual shall not be copied, translated, stored in database or retrieval system, also can’t spread through electronic, copying, record ways. Thanks for purchasing our product. In order to let customers use it better and reduce the faults caused by misuse, please read the manual carefully and operate it correctly in accordance with the instructions. If users disobey the terms or remove, disassemble, change...

Zhengzhou Winsen Electronics Technology Co., Ltd Electrochemical Carbon Monoxide Gas Module ZE16B-CO Profile ZE16B-CO electrochemical carbon monoxide detection module. It utilizes electrochemical principle to detect CO in air which makes the module with high selectivity and stability. It is a combination of mature electrochemical detection principle and sophisticated circuit design. Features High sensitivity, fast response, good working stability, pre-calibrated Main Applications Household CO alarm gas and CO detector. Technical Parameters Interfering gases Output data Working voltage Preheating...

Zhengzhou Winsen Electronics Technology Co., Ltd Definition of pins PWM output 500ms is one period (20%~80% is corresponding 0~500ppm) Alarm status: high electrical level output if concentration ≥150ppm) NOTE: When the UART serial port is used, the PIN4 RX pin cannot hang in the air Stable2. Pins Communication Protocol 1. General Settings Table 3 Baud Rate Data bits Stop Bits 2. Communication Commands The communication is initiative upload mode, concentration value is sent every other 1s, command line as follow (300ppm concentration): Byte0 Start Byte (High Byte) Full Range Full Range (High Byte)...

Zhengzhou Winsen Electronics Technology Co., Ltd Installation This module adopts Pin2.54mm*4 and Pin2.54mm*2 single row pin structure for external connection. It is just need to weld the positioning needle to the fixed connection and the welding is manual mode. DO NOT insert or extract the sensor on the PCB board. DO NOT change or move the electronic part on the module. Avoid sensor contact with organic solvent, coatings, medicine, oil and high concentration gases. Excessive impact or vibration should be avoided. Please keep the modules warming up for at least 20 minutes when first using. Please...