Zhengzhou Winsen Electronics Technology Co., Ltd Carbon Monoxide Module （Model No.：ZE16-CO） Zhengzhou Winsen Electronics Technology Co., Ltd. Tel: 86-371-67169097 67169670 Email: [email protected] Leading gas sensing solutions supplier in

Zhengzhou Winsen Electronics Technology Co., Ltd Statement This manual’s copyright belongs to Zhengzhou Winsen Electronics Technology Co., LTD. Without the written permission, any part of this manual shall not be copied, translated, stored in database or retrieval system, also can’t spread through electronic, copying, record ways. Thanks for purchasing our product. In order to let customers use it better and reduce the faults caused by misuse, please read the manual carefully and operate it correctly in accordance with the instructions. If users disobey the terms or remove, disassemble, change...

Zhengzhou Winsen Electronics Technology Co., Ltd Electrochemical Carbon Monoxide Gas Module ZE16-CO Profile ZE16-CO electrochemical carbon monoxide detection module. It utilizes electrochemical principle to detect CO in air which makes the module with high selectivity and stability. Built-in temperature sensor can do temperature compensation; and it has digital output and analog voltage output. It is a combination of mature electrochemical detection principle and sophisticated circuit design. Features High sensitivity, fast response, good working stability, pre-calibrated. Main Applications Household...

Zhengzhou Winsen Electronics Technology Co., Ltd Definition of pins Reserved Preheating mode: 1.25s high electrical level, 1.25s low electrical level, the electrical level cycle lasts for 30s. Low electrical level output once preheating done. Alarm status: high electrical level output at 150ppm) PWM output, 50ms is a cycle (20%-80% duty ratio is corresponding to 0-500ppm ) Stable2. Pins Communication Protocol 1. General Settings Table 3 Baud Rate Data Byte Stop Byte Check Byte 2. Communication Commands The communication is initiative upload mode, concentration value is sent every 1s, command...

Zhengzhou Winsen Electronics Technology Co., Ltd { unsigned char j,tempq=0; i+=1; for(j=0;j<(ln-2);j++) { tempq+=*i; i++; } tempq=(~tempq)+1; return(tempq); } DO NOT insert or extract the sensor on the PCB board. DO NOT change or move the electronic part on the module. Avoid sensor contact with organic solvent, coatings, medicine, oil and high concentration gases. Excessive impact or vibration should be avoided. Please keep the modules warming up for at least 5 minutes when first using. Please do not use the modules in systems which related to human being’s safety. Please do not use the modules...