Zhengzhou Winsen Electronics Technology Co., Ltd Zhengzhou Winsen Electronics Technology Co., Ltd Email: [email protected] Leading gas sensing solutions supplier in Ch

Zhengzhou Winsen Electronics Technology Co., Ltd ME3-HCL gas sensor ME3-HCL electrochemical sensor detect gas concentration by measuring current based on the electrochemical principle, which utilizes the electrochemical oxidation process of target gas on the working electrode inside the electrolytic cell, the current produced in electrochemical reaction of the target gas are in direct proportion with its concentration while following Faraday law, then concentration of the gas could be get by measuring value of current. 1. Features * Low consumption * High precision * High sensitivity * Wide linear...

Zhengzhou Winsen Electronics Technology Co., Ltd 5.Characterization Features of Sensitivity, response and resuming Data graph of concentration linearity features Output signal/μA Output signal/μA Zero point changing upon Variable Temperature Output upon variable temperature Output signal/20℃ Output signal/ppm Email: [email protected] Leading gas sensing solutions supplier in

Zhengzhou Winsen Electronics Technology Co., Ltd 7. Anti-Interference: ME3-HCL sensor also responds to other gases besides target gas. Below are the response characteristics of interferential gases Sensor shall Avoid organic solvent, coatings, medicine, oil and high concentration gases； All ME Sensors shall not be encapsulated completely by resin materials, and shall not immerse in oxygen-free environment, otherwise, it will damage the function of sensor； All ME sensors shall not be applied in corrosive gas environment, or the sensor will be damaged； Please test the sensitivity of gas sensors...

Zhengzhou Winsen Electronics Technology Co., Ltd Blowhole of the sensor should not be blocked and polluted, which will cause the sensitivity decrease; Excessive impact or vibration should be avoided； Do not use the sensor when the shell is damaged； It takes some time for the sensor to return to normal state After applied in high concentration gas； Do not take apart the sensor, otherwise electrolyte leakage can cause sensor damage; Working electrode and reference electrode of the sensor shall be in short circuit when stored.； To preheat over 48hs before using and soldering forbidden; Note: To...