Electrochemical O3 Sensor (Model: ME2-O3-16×15) Manual Version: 1.1 Valid Date: 2016-05-22 Zhengzhou Winsen Electronics Technology Co., Ltd

Statement This manual copyright belongs to Zhengzhou Winsen Electronics Technology Co., LTD. Without the written permission, any part of this manual shall not be copied, translated, stored in database or retrieval system, also can’t spread through electronic, copying, record ways. Thanks for purchasing our product. In order to let customers use it better and reduce the faults caused by misuse, please read the manual carefully and operate it correctly in accordance with the instructions. If users disobey the terms or remove, disassemble, change the components inside of the sensor, we shall not...

Zhengzhou Winsen Electronics Technology Co., Ltd ME2- O3- 16x15 O3 gas sensor ME2-O3-16x15 electrochemical gas sensor is fuel cell type, which utilizes the electrochemical oxidation process of O3 gas on the working electrode. The current produced in electrochemical reaction of the target gas are in direct proportion with its concentration while following Faraday law, then concentration of the gas could be get by measuring value of current. Features * Low consumption * High precision * High sensitivity * Wide linear range * Good anti-interference ability * Excellent repeatability and stability...

Zhengzhou Winsen Electronics Technology Co., Ltd Testing Circuit Characterization Features of Sensitivity, response and resume Output upon variable temperature Linearity features Zero point output upon Variable Temperature Email: [email protected] Leading gas sensing solutions supplier in China

Zhengzhou Winsen Electronics Technology Co., Ltd There are two ways to fix the ME2-O3-16×15 sensor Fix the sensor in PCB or instrument shells through fixing hole by using nut Fix the sensor through the fixing slot Fixing Hole Fixing Slot Cross interference gas: ME2-O3-16x15 sensor also responds to other gases besides target gas. Below are the response characteristics of interferential gases Do not break and bend the PCB terminals; To preheat for no less than 48hs before using; Do not take apart the sensor, otherwise electrolyte leakage can cause sensor damage; Sensor shall avoid organic solvent,...

Zhengzhou Winsen Electronics Technology Co., Ltd Sensors shall be avoided to face the gas, which flow directly from front side； Blowhole of the sensor should not be blocked and polluted, which will cause the sensitivity decrease; Do not open and damage the above waterproof breathable membrane of the sensor; Excessive impact or vibration should be avoided； Do not use the sensor when the shell is damaged； It takes some time for the sensor to return to normal state after applied in high concentration gas； Working electrode and reference electrode of the sensor shall be in short circuit when stored；...