DIN-RAIL CONTROLLER Main Features: • PID Autotune DIN-Rail controller • 3%o re-transmission accuracy • All plug-in connections • Multi input signal: TC, RTD, mA, Volts • RTD type PtIOO/PtlOOO selectable • Multi output: Relay, SSR logic, mA, Volts • RS485 serial interface MODBUS/RTU protocol • Opto isolated digital input feature • RAMP set-point • Input/Output galvanic isolation • Network or standalone operation • Automatic/Manual operation • Heating/cooling control selectable • Two configurable relay alarms • Second control set-point selectable • Offset input signal selectable • 24Vcc Power output for two wire transmitters • Power in 21-48Vdc/ac • Dimensions 116X100X22. 5mm General Specifications:

Connection&Dimension Side 1 Side 2 TAISUO TECHNOLOGY Dimension L ®—i, ©—- A POWER SUPPLY 21..48VacMc see manual | | | Supressing at Power-on Setup M2 Setpoint AI2 Hi ste * Users set all parameters through this Conf-CH software * The register and coil address is referred in the instruction manual © Copyright 2009 Taisuo Technology Co. -All Rights Reserved Output actio ft Direct C Reverse TAISUO TECH. NINGBO 315400 P. R. C.