WAVE SPRING <<< SPIRAL RETAINING RING <<< LINEAR WAVE SPRING FflOMCTINTRQMCTION Round wire wave spring is produced from a circular section of steel wire, which can provide higher loads while maintaining precise spring loads. As an alternative to the dished spring, the circular coil provides a similar load, but with a more accurate, predictable spring stiffness. • Suitable for very high forces and more compact radial Spaces • Reduce or eliminate vibration during pretension • Can replace the disc spring • Standard parts available from 12.7mm tol 52.4mm • Custom parts available from 4mm to 3000mm Round wire wave spring from stock in carbon and 63 I stainless steel: SERIES DIAMETER MATERIAL | PRODUCT INTRODUCTION Linear wave spring is a continuous corrugated wire made of elastic tempered material. As a load-bearing device, they have approximately the same load and stroke characteristics as cor rugated springs. The axial pressure is obtained by laying the spring flat on a straight line. Linear wave spring from stock in carbon and 63 I stainless steel: SERIES LENGTH MATERIAL SINGLE TURN FOR RORE SINGLE TURN FOR SHAFT I PRODUCT INTRODUCTION Spiral retaining ring is formed by flat wire winding elastic ring, no lug, no burr, will not interfere with the parts, and different from the traditional stamping process , will not produce waste caused by waste. •No gap - 360°retaining surface •No protruding ears interfere with mating components •The coiling process produces no scrap ©Easy installation and removal •No-Charge on custom design ©Standard parts available from 6mm to 400mm •Custom parts available from2mm to-3000mm Single turn for bore from stock in carbon and 304 stainless steel: Single turn for shaft from stock in carbon and 304 stainless steel: