ISPRIN WAVE SPRING <<< WAVE SPRING <<< I PMDUCTHTMMICnm Single turn wave spring washer can be used in a variety of applications, mainly for short travel and low load applications. Can provide reliable and accurate linear load output. During compression, the free end of the spring expands flexibly. If the spring is limited in the hole, it will not cause the phenomenon of stamping closed wave washer stuck, this design greatly improves the fatigue performance and service life, so as to effectively reduce the cost. The ends of the lap wave washer partially overlap on the circumference of the wave. SINGLE TURN OVERLAP WAVE SPRING SINGLE TURN GAP WAVE SPRING NESTED WAVE SPRING FEATURES AND BENEFITS • Used for short trips and medium and low load situations • Provides reliable and accurate linear load output • Notched type facilitates stacking and height reduction • It is suitable for small diameter to avoid wrapping • Standard parts available from 9mm to 580mm • Custom parts available from 2mm to 1500mm | PRODUCT INTRODUCTION The nested wave spring is made of a continuous flat wire stacked in parallel. Stacking individual springs for higher loads is no longer necessary. The spring stiffness of nested wave springs increases in proportion to the number of layers. They can generate tremendous force, but at the same time maintain the accuracy of the spring. Nested wave spring replace dish springs in many applications, especially where high and precise forces are required. FEATURES AND BENEFITS Gap wave spring washer from stock in carbon and 17-7PH stainless steel: