SPIRAL RETAINING RING <<< ROUND WIRE WAVE SPRING LINEAR WAVE SPRING PRODUCT INTRODUCTION Round wire wave spring is produced from a circular section of steel wire, which can provide higher loads while maintaining precise spring loads. As an alternative to the dished spring, the circular coil provides a similar load, but with a more accurate, predictable spring stiffness. • Suitable for very high forces and more compact radial Spaces • Reduce or eliminate vibration during pretension • Can replace the disc spring • Standard parts available from 12.7mm tol 52.4mm • Custom parts available from 4mm to 3000mm Round wire wave spring from stock in carbon and 63 I stainless steel: SERIES DIAMETER MATERIAL Spiral retaining ring is formed by flat wire winding elastic ring, no lug, no burr, will not interfere with the parts, and different from the traditional stamping process , will not produce waste caused by waste. 'The coiling process produces no scrap «Easy installation and remova No protruding ears interfere with mating components Linear wave spring is a continuous corrugated wire made of elastic tempered material. As a load-bearing device, they have approximately the same load and stroke characteristics as corrugated springs. The axial pressure is obtained by laying the spring flat on a straight line. • Suitable for low to moderate loads and deflection • Used in linear cavities where spring forces are required • Standard parts length from 38.1 mm to 304.8mm • Custom parts length from 5mm to 2000mm Linear wave spring from stock in carbon and 63 I stainless steel: SERIES LENGTH MATERIAL PRODUCT INTRODUCTION No-Charge on custom design Single turn for bore from stock in carbon and 304 stainless steel: