Technical data sheet MNK-L-RP-N Multi-jet semi-dry-dial meter for cold water MNK-L-RP-N is a MID-compliant water meter for service connection. The current state of development guarantees the most precise measurement results, minimal bearing load and a long service life. The meter is equipped with a reed switch interface as standard. The interface enables remote reading of the meter data via PDC radio module with LoRaWAN® or wM-Bus (according to OMS). The rollers of the MNK-L-RP-N are protected in a separate chamber that is filled with a special protective liquid. This means that the rollers can always be read even when the water is very dirty. The housing of the MNK-L-RP-N is made of glass-fibre reinforced polymer plastic, drinking water approved and able for an operating pressure up to 16 bar. Performance characteristics at a glance ■ Multi-jet semi-dry-dial meter For horizontal and vertical installation Register cap made of UV-resistant plastic Housing made of glass-fibre reinforced polymer plastic Around 50% lighter than a comparable meter with brass For the consumption measurement of cold and clean drinking water or service water up to 30 °C Serially equipped with communication interface for PDC-module (PulseDataCapture): Approved in accordance with MID – PDC-wireless M-Bus radio module according to OMS-Standard (868 MHz), EN 13757-4 – PDC- LPWAN-Radio module for LoRaWAN® ■ Retrofittable with pulser

Technical data Permanent Flowrate Comparable to nominal flow (EEC) Attainable measuring range 1 Comparable to metrological class (EEC) Overload Flowrate Transitional Flowrate Start-up flow rate Display range Temperature range Operating pressure Pulse value (Reed-Pulser oder PDC) Pressure loss class at Q3 Mechanical environmental condition Flow profile sensitivity Dimensions and weights: Nominal diameter Overall length without connectors Overall length with connectors approx. Width approx. Height approx. Weight approx. Other measuring ranges (R) on request 2 The data refers to the maximum measuring...