pumpBOX Lifting Stations
8Pages

better together WASTEWATER LIFTING STATIONS DOMESTIC AND RESIDENTIAL

better together Do you need to reach a sewer system that's too far away or at a higher level? With pumpBOX you can. pumpBOX is a pre-assembled lifting station certified in accordance with EN 12050-1 and 12050-2 standards for collecting and pumping wastewater from residential wash basins, toilets, showers and washing machines into the sewer system when a gravity feed is not available or it is too far away. pumpBOX combines a robust polyethylene tank with a single or dual Zenit pump, resulting in a complete system for the collection and lifting of black and grey water from domestic and...

Tank in PE, EN 12050-1, 12050-2 certified Rated volume 75 litres (GR version) or 115 litres (DG version) White, allowing immediate verification of the liquid level inside Strong one-piece construction with internal reinforcement feet Low noise levels (<70 dB), sealed against liquids and odours Large Ø 90 mm inspection window on top wall GR version (grinder pump) or DG version (vortex pump) Single or dual pump version Maintenance-free PVC fittings and check valves (GR version) Double check valve in UNI flanged cast iron (DG version) Float for maximum level alarm as standard Automatic start/stop...

better together 1 Thick polyethylene tank, with a hermetic seal against odours and liquids. Strong one-piece construction with internal reinforcement feet and slots for fastening to the floor integrated into the casing. Maximum level alarm via stainless steel float switch. Pump start/stop device via pressure sensor. Prepared for inlet pipes from above or from side and rear walls (standard height: h 180, 250, 315 mm for direct connection to the WC). Gaskets Ø 75-110 mm, included. 2 Internally shaped bottom to facilitate the suction of solids and reduce the accumulation of sediment which can...

Automatic start/stop device The pump is started and stopped by an automatic device able to detect the level of the liquid in the tank. The system can use a pressure sensor which is connected to an electrical control panel. The device is housed inside the tank and can be removed through a large Ø 90 mm inspection window by unscrewing the tightly sealed ring nut of the cover. Pressure sensor START 2 H2 START 1 H1 STOP For constant detection of the level of the liquid and for setting the start/stop thresholds for the main and the secondary pump (if installed). Thanks to its wide reading range,...

better together impeller with cutting knife H (m) vortex impeller no. / pumps

- impeller with cutting knife - single pump version 525 - impeller with cutting knife - dual pump version 162 - vortex impeller - single pump version - vortex impeller - dual pump version

better together For further information, visit www.zenit.com The data provided are not binding. Zenit reserves the right to modify the product without advance notification. The digital version of this catalogue is available for download at: www.zenit.com/download