Datasheet Z-Fiber High-end fiber laser with active cooling The ZFSM series has been developed for the most demanding applications in the market. Wherever an exceptional beam quality for high-resolution measurements or medical use is needed, the ZFSM series is the right choice. The user can choose from blue, green and red wavelengths depending on the application requirements. The projection quality is superior to any available free-space solution in the market. The laser along with its intelligent monitoring functions enables a high stability in performance. The integrated active cooling system supports an extended lifetime and stable operation. The laser can be integrated efficiently in a sophisticated machine vision, medical, or life science setup to its communication interfaces (RS-232 & I²C). Highlights • Single-mode fiber with FC/PC connector • Optical output power up to 35 mW • Unique line uniformity and µ-optics for thin lines • Red, green and blue wavelengths Machine Vision • Fail-safe for critical applications (e. g. medical) • OEM-version without housing and TEC (PCB-version) • Analog and simultaneous TTL modulation up to 200 kHz Order Code - Product family Size of head

Datasheet Z-Fiber System specification Wavelength tolerance nm (typical) Wavelength drift nm (temperature stabilized, over total operating temperature) Output power Spatial mode (20 Hz bis 20 MHz, typical) Peak-to-Peak Noise (20 Hz bis 20 MHz, typical) mrad (typical) Pointing stability Laser operation mode Single transversal mode Power stabilized (integrated TEC) Electrical specification Electrical isolation Over temperature protection and LED pre-failure indicator, reverse polarity and transient protection (ESD, burst & surge) Potential-free housing M12 plug 4-pin, Sub-D plug 9-pin Communication...

- plp = p-line Powell; very thin lines with smaller depth of focus (only available for fan angles 10° and 20° at working distances < 150 mm) - Ip = line Powell; standard setup for working distances > 150 mm The graphs above show the values for line width and depth of focus of a 450 nm laser. To get the values for a different wavelength the factor from the table above has to be multiplied by the values from the graphs. Example: 450 nm laser focused at 90 mm working distance: line width approx. 9 pm (@ plp optic); Depth of focus approx. 0.7 mm (values from the graphs) Calculated: 640 nm laser focused...

Datasheet Z-Fiber Mechanical Specifications Weight Head Electronics (housed version) Housing PCB Fiber length 0.13 0.9 105.25 x 82.5 x 36.6 | 4.14 x 3.25 x 1.44 70 x 60 | 2.76 x 2.36 (PCB-version) 450 | 17.72 (plus FC / PC connector) Aluminum (black anodized) Protection class Rear view This surface needs to be mounted on a heat sink M12 4-Pin: A-Coding Male Connector 1 Analog-Modulation (0-2 VDC) CE-Conformity according to the directives 2014/30/EU, 2011/65/EU and 2006/25/EU. Subject to technical change. Version: October 2023 Optical head must not be clamped