Catalogs >
Yueqing RunEasy Electronic Technology Co.,Ltd. >
Single phase 100A latching relay TP41-28

Single phase 100A latching relay TP41-28
3Pages

Catalog excerpts

Single phase 100A latching relay TP41-28 - 1

Relay Technical Data Single phase 100A latching Relay TP41-28 Description ● Single Phase 100A Switching Capability; ● Multi-layer blades, Low temperature rise; ● Low contact resistance; ● Customized shunt, copper braid cables; ● Environment protection (Comply with ROSH); Contact Material: AgSnO 2 Part No.: Single phase 100A Switching D: Double Coil S: Single Coil Type: Magnetic latching relay Technical Data Coil data Rated coil voltage Single Coil Double Coil pulse Width pulse time Contact data Contact data ContactMaterial: Contact Contact arrangement Contact Resistance: Mechanical Life Electrical Life

Open the catalog to page 1

Single phase 100A latching relay TP41-28 - 2

Standard windings Operating voltage range MAX. (VDC) Nominal voltage (VDC) Single Winding Double Winding NOTE: Others norminal voltage required, special ordering allowed. Insulation Resistance: Dielectric strength Between Contact and Coil Between Open Contact Creepage Distance: Shock Ristance: Vabration Resistance: Ambient Temperature: Dust protection Electrical Endurance UC Class Power factor Close Open time(s) Electrical Endurance(OPS) 5000 Cycle 5000 Cycle NOTE: Electrical endurance confirm to IEC62055-31 UC3 testing requirement, do the inductive load testing after the resistance load...

Open the catalog to page 2

Single phase 100A latching relay TP41-28 - 3

Outline dimensions and circuit diagram Remark: The tolerance didn’t mark on drawings. When dimension is≤1mm,the tolerance should be less than ±0.2mm ; when dimension is between 1-5mm, the tolerance should be less than ±0.3mm; When dimension is ≥5mm, the tolerance should be less than ±0. 5mm. Note: 1. The default status of the relay contact is closed( Reset), it maybe change to “open” due to transit or relay mounting, please check the contact status when using, and reset the relay contact status on request if necessary. 2.In order to make sure the contact “ open” or “closed” status, the...

Open the catalog to page 3