Yosaite Materials Technical Data Sheet /BC660B Description Cation emulsified bitumen waterproof coating is made from cationic bituminous emulsion, synthetic resins, and mineral stabilizers. It is cold applied, single component product that yields a membrane with excellent strength, elasticity, and adhesion. The high performance coating is VOC free, non toxic, and no pollutions and the film is seamless. It can be used also as a primer if diluted with water. Features ♦ Environment friendly, single component, free of solvents or any hazardous substance ♦ High elongation and excellent flexibility ♦ Can be applied on damp surface with strong adhesiveness and water tightness ♦ Suitable for use confined areas, seamless and no joint gap, easy application ♦ Good aging and corrosion resistant, non toxic, long service life Uses It can be widely coated on horizontal and vertical surfaces include masonry, mortar, concrete, metal, wood, plastic, glass, plaster board, foam board, asphalt, rubber, SBS membranes, such as roofs, shower room, interior and exterior wall, road, bridge, swimming pool, tunnel, parking, and residential and commercial buildings etc. Yosaite Construction Materials Co. Ltd. No.467, Changjiang Middle Rd., Huangdao District, Qingdao, China Tel: +86 532 8610 7250 Fax: +86 532 8610 7250 ext. 208

05* Yosaite Materials Technical Data Sheet /BC660B Packing 20kg/pail or customized Coverage 1mm thickness dry film costs the coatings at 1.8-2.0kg/m2, coverage may vary with the substrate conditions during application. Recommended consumption per coat 0.4-0.6kg/ kg/m2; As a primer 0.4-0.6 kg/m2. Application instructions Surface Preparation: Substrates need to be clean, smooth, dry (Moisture <9%), no grit and free of sharp edges, loose or foreign materials, oil, grease and other materials that may damage the coating film. All surface voids greater than 5mm wide, shall be properly filled with an...