PCB Depaneling Machine ARMAS Router Fast and accurate routing of offline type A machine for depaneling PCBs, the ARMAS Router rotates the drill bit at a high speed routing through the contour of the PCB freely. Bronze model Silver model Platinum model 1 spindle configuration for small volumes Multi spindle configuration for reduced working time and maximized productivity Features · Configuration for periodical Bit usage and notification for Bit damage · Vision camera for previewing & setting routing area · Dust collector is installed for high efficient fume extraction (extraction from the bottom)...

ARMAS Router Features (Standard) Bit usage cycle setting It is possible to use one bit several times by setting its usage time. Bit usage is determined by the cutting length. Cutting can be divided from steps 1-3 according to the total Flute length. If the cutting length (usage) is set according to the characteristics of the board, the bit will check the cutting motion. If usage exceeds what was set, Z axis will automatically move to the next step for cutting. ex) Flute Length · Initialization or before cutting, verification is done to check if bit broke or slipped down from its original position....

(Only available function on PlatinumModel) · Replace JIGs easily and rapidly with the Easy Release Lever during model change-overs. · Rotate the dial On/Off to release and lock the JIG. · Each JIG stage comes equipped with a Cradle that stores up to 3 bits. Affixing the bits beforehand allows a total of 6 bits to be stored on one machine. · If the bit breaks or wears out during operation etc. and cannot be used, the bit is automatically replaced. ARMAS Router Features (Option) Barcode Reading Fiducial Check · Function to read the barcode on a PCBA or Jig to check if the selected model from the...

ARMAS Router Standard / Option Spec. [ Standard ] Spec. Vision camera * MV-CE015-50GC Dust collector * Bit Multi stage control, Damage detection Uninterruptible power supply Safety sensor Fiducial Check Area Sensor [ Option] Spec. Light curtain Z/X-axis control Spindle independent control JIG Barcode Reading Communicate with Robot-Arm Spindle Monitoring System Additional JIG 2pcs (1set) Dust collector * - Dust bag type (ECM-2PB) MES * (Complexity - middle/low) MES * (Complexity - high) Color - ESD Powder coating(RAL 7035) For correct guidance of quotation and manufacturing process, the below...

Spec. Infomartion * Item Chuck clamping range Speed range The component height limitation nearby the cutting bridge. (Based on Ionizer Vision Camera Automatic Bit replacement, Bit station included - Component height above 19mm cannot be accommodated within 9mm radius of the bit - Component height above 17mm cannot be accommodated within 8mm radius of the bit - Component height above 15mm cannot be accommodated within 5mm radius of the bit - Component height above 38mm, pls contact sales team separately. - Component height above 26mm cannot be accommodated within 18mm radius of the bit - Component...

ARMAS Router Line up Servo motors Air Usage (ℓ/min) Weight (kg) SR RAL 7035 + Doosan Dark gray Electricity Consumption(kw) * X : X axis Spindle Y : Y axis JIG Z : Z axis Spindle ** Applies when selecting the SycoTec 4025 spindle option for Bronze model

Head Office 110, Secheon-ro 1-gil, Dasa-eup, Dalseong-gun, Daegu, 42921 Korea TEL +82-53-592-1723 FAX +82-53-592-1724 E-mail [email protected] www.yjlink.com