The Yamada Powder Transfer Pumps were specifically designed to move bulk solids more effectively throughout your process. They are a cost effective replacement for Augers and Conveyors and eliminate unsafe and labor intensive means of moving bulk powders. These heavy duty pumps consistently transfer fine-grained (1 OOum or finer), low bulk density dry powders in a dust-free operation. v ^ Yamada offers a base unit specifically for light / powders, which include the following %^1T standard features. • Conveying distance depends upon the micron size and the bulk density of the powder. For example, fumed silica can be conveyed a maximum of 150 feet (45m). Flour can be conveyed a maximum of 40 feet (12M). Refer to the Yamada "Pumpable Powders" data sheetfbr specific materials. • Powder must be 150 mesh(106 micron)or smaller size particle / powder and dry. The Pump will not pump crystals or flakes and the bulk density should be less than 50lbs/cubic feet.(0.8kg/liter) The higher the bulk density, the shorter the conveying distance and the lower the flow rate. • The Pump can be located a maximum of 15feet(4.5M) above powder source. • Yamada recommends aeration /fluidization of the powder a minimum of 10 to 15 seconds prior to starting the pump- premature diaphragm, center shaft, and center disk failure • PTFE check balls are recommend for sticky powders. • Yamada recommends regulating compressed air to Activated Carbon Acrylic Resins Aluminum Oxide Carbon Black Cereal Flours Clay Powder Diatomaceous Earth Expanded Mica Fire - extinguishing Fumed Silica Ground Limestone Micro Dolomite Filter Powder Coatings Powdered Plastics Powdered Rock Quartz Powder Salicylic Acid - Apparent specific gravity is 0.5 or less - Angle of respose is 30 degree or less - Powder must be completely dry - Powder must have large fluidity The performance data for powder transfer is highly dependent upon the material being pumped and the application. A trial of the pump in the actual use environment is recommended to verify the actual performance capabilities for

Powder Transfer Diaphragm Pumps NDP-80 NDP-25 NDP-40 NDP-50 BAC BAN BSC BSN BAC BAN BSC BSN BAC BAN BSC BSN BAC BAN BSC BSN 3”(80A) 1”(25A) 1-1/2”(40 A) 2”(50A) Model Nominal port size Connection to liquid Inlet Outlet Inlet Air connection Outlet Ball seat Center disk Air supply pressure range Max discharge pressure Max discharge volume Max air consumption Max slurry diamaeter Ambient temp range Noise level Weight Non wetted body Diaphragm, Ball Wetted body Your Local Distributor: International Department No.1-3, 1-Chome, Minami-Magome, Ohta-ku,Tokyo 143-8504, Japan E-mail: [email protected]...