MINIATURE HIGH POWER RELAY Features 6A switching capability; Multi contact arrangements: 2NO+2NC, 3NO+1NC; Forcibly guided contacts according to IEC 61810-3; High insulation capability: 6kV surge voltage between input and output; ● UL insulation system:Class F; ● Outline dimensions：(35×12.6×25.5)mm. ● ● ● ● RoHS compliant CONTACT DATA Contact arrangement Contact resistance Contact material Contact rating(Res.) Max.swtiching voltage Max.switching current Max.switching power Mechanical endurance Electrical endurance Coil power Notes:1)The coil holding voltage is the voltage applied to coil 100ms after the rated voltage. COIL DATA Nominal Voltage VDC 23℃ Drop-out Max. Voltage Allowable VDC Voltage min VDC Between coil & contacts Dielectric Between open contacts strength Between contact sets Insulation resistance Notes:1)The data shown above are initial values. Notes:1)The data shown above are initial values. 2) Max. voltage refers to the maximum voltage which relay coil could endure in a short period of time. Surge Voltage SAFETY APPROVAL RATINGS 6A 250VAC Resistive load 85℃ Operate time (at nomi. volt.) Release time (at nomi. volt.) Functional Shock resistance Destructive Vibration resistance Ambient temperature Termination Flux proofed Unit weight Notes:1)The data shown above are initial values. Notes: Only typical loads are listed above. Other load specifications can be available upon request.

ORDERING INFORMATION Type Coil voltage Contact arrangement Contact material Insulation class Contact plating XXX: Customer special requiremen；Nil: Standard Notes: 1) Contact is recommended for suitable condition and specifications if water cleaning or surface process is involved in assembling relays on PCB.; 2) For Au plated contacts, the min. load is 10mA 5VDC. If the customer has a special load, please contact us to evaluate and provide the appropriate product specifications; 3) The customer special requirement express as special code after evaluating by Hongfa. OUTLINE DIMENSIONS, WIRING DIAGRAM...

OUTLINE DIMENSIONS, WIRING DIAGRAM AND PC BOARD LAYOUT Wiring Diagram(Bottom view) Notes:1) In case of no tolerance shown in outline dimension: outline dimension ≤1mm, tolerance should be ±0.2mm; outline dimension＞1mm and ≤5mm,tolerance should be ±0.3mm; outline dimension＞5mm and ≤30mm, tolerance should be ±0.4mm;outline dimension＞30 mm, tolerance should be ±0.6mm. 2) The tolerance without indicating for PCB layout is always ±0.1mm. Disclaimer The specification is for reference only. See to "Terminology and Guidelines" for more information. Specifications subject to change without notice. We...