CS-PT807 Series Pressure TransmitterCS-PT807 Applications • General pressure measurement • Machinery manufacturing • Measurement and control technology • Kerosene pressure measurement • Nitrogen and helium pressure measurement PT807 pressure transmitter adopts sputtered film core, has 0.2~4.8VDC output signal, Y4-4ZJBM connector with 1.5m cable, and M18 x 1.5 pressure interface with inner screw sleeve, can be used for pressure measurement of nitrogen, helium, kerosene and other media. This series of pressure transmitters can be customized as different pressure interfaces, electrical interfaces and signal outputs. • Sputtering film pressure sensor • High overload pressure and high burst pressure • Fully welded structure, no O-ring, no risk of leakage • Electrical connection: Y4-4ZJBM (with 1.5m cable) • Pressure connection: M18 x 1.5 Female (with threaded sleeve) • Over voltage and reverse voltage protection

CS-PT807 Series Pressure TransmitterPerformance Specifications Temperature 25°C, power 15VDC, RH 45%~75%, Atmospheric pressure 86—106KPa.

CS-PT807 Series Pressure Transmitter Notes a. The pressure transmitter must be used in the medium that is non-corrosive to the seal material and the housing material. b. In case the pressure guiding hole of the transmitter is blocked, it is forbidden to use sharp tools to clear it. Instead, one should remove the transmitter from the system, immerse the pressure guiding hole part in the liquid which can dissolve the blockage, and then the blockage will flow out easily. c. It’s prohibited to open the transmitter by users for calibration or repair. d. Please contact us if you’re not sure whether...