CS-PT300M Pressure Transmitter （Product Specification） XI'AN CHINASTAR M&C LIMITED

CS-PT300M Series Pressure TransmitterRevision History Date Note: The revised resume on this page is for internal viewing only.

CS-PT300M Series Pressure Transmitter Applications • Industrial refrigeration unit • Precision computer room air conditioning • Interrow refrigeration air conditioning • Air source heat pump PT300M pressure transmitter for refrigeration with fully welded structure is widely used in air conditioning, refrigeration and heat pump systems. Industry standard 0.5~4.5V signal output, international electrical connectors and pressure ports, all-welded structure, anti-condensation, suitable for refrigerant pressure measurement. This product allows to control and ensure that the system operates under safe...

CS-PT300M Series Pressure TransmitterPerformance Specifications Temperature: 20~25°C; Power supply: 5VDC ; Relative humidity: 45%~75%; ambient atmospheric pressure: 86KPa~106KPa;

CS-PT300M Series Pressure Transmitter CHINASTAR

CS-PT300M Series Pressure Transmitter Electrical Connection Packard Metri-Pack

CS-PT300M Series Pressure TransmitterModel Selection Tips PT300M Series Pressure Transmitter 1. The transmitter must be used in a medium that is not corrosive to the sealing material and housing material. 2. When the pressure-guiding hole of the transmitter is blocked, it is strictly forbidden to use a sharp tool to clear the pressure-guiding hole. The transmitter should be removed and the pressure-guiding hole should be immersed in a liquid that can dissolve the blockage. After the blockage is dissolved, remove it fall out. 3. It is strictly forbidden to open the transmitter for calibration...

CS-PT300M Series Pressure Transmitter After the end of the product life, each part shall be distinguished according to the “National hazardous waste list” to determine whether it is hazardous waste. Among them, the waste lithium battery not disassembled is not hazardous waste, and the waste circuit board (including components, chips, plug-ins, pins, etc. attached to the waste circuit board) belongs to hazardous waste. The part that is not hazardous waste shall be treated as general industrial solid waste, and the lithium battery shall be handed over to the nearby renewable resource recovery department...