Catalog excerpts
ATG-3000 Series Power Signal Generator It can output sine wave, square wave, triangle wave, and pulse wave The input signal can be built-in or external Maximum output power 810Wp Bandwidth（-3dB）DC~100kHz The ATG-3000 Series is an ideal power signal LCD display of equipment status, parameter generator that outputs sine waves, square waves, settings etc., simple and easy to understand. triangle waves, and pulse waves. Customers can choose internal or external input signal based on the usage. With a maximum output of 810Wp, it can drive power-type loads. The input interfaces of ATG-3000 series are BNC The output ports of the ATG-3000 series are interfaces. When in FWG mode, the built-in input banana sockets, and the output resistance is signal will be used, just need to set up the parameters. When in AMP mode, the signal is externally connected, the input resistance is 5kΩ, the output resistance can be switched, and the voltage gain can be adjusted to achieve signal amplificatio
Open the catalog to page 1
Single output Differential output Single output Maximum output voltage Maximum output power Voltage gain Maximum output current Load RL upper limit Output resistance Slew Rate Input resistance Input amplitude Output voltage error Total harmonic distortion (THD) Output voltage zero-point drift Signal-noise ratio(SNR) Output connector Overcurrent protection Signal ground Ground connected with the case and the power line Supply voltage
Open the catalog to page 2All Xi'an Aigtek Electronic Technology Co. catalogs and technical brochures
Archived catalogs
-
Power amplifier ATA-3090C2 Pages
-
ATA-M Series Power Amplifier2 Pages
-
ATA-P Series Power Amplifier3 Pages
-
ATA-L Series Power Amplifier4 Pages
-
ATA-5000 Series Preamplifier3 Pages
