ATA-M2 Power Amplifier

Product catalog summary

Introduction
The ATA-M2 is a single-channel power amplifier designed for high-performance applications. It offers a maximum output voltage of 175Vrms, continuous power of 200VA, and pulse power up to 500VA. The device is suitable for driving both resistive and non-resistive loads with adjustable output impedance.

Specifications

Maximum Continuous Output Power: 200VA
Maximum Pulse Output Power: 500VA
Bandwidth: 10kHz to 500kHz
Maximum Output Voltage: 175Vrms
Total Harmonic Distortion (THD): ≤0.5% at 50kHz, 42Vrms
Input Voltage for Full-Scale Output: 1Vrms
Input Impedance: 10kΩ
Protection Features: Over Temperature, Over Voltage, Short Circuit, and No Load Protection
Operating Temperature: 0°C to 45°C
Storage Temperature: -20°C to 50°C
Working Humidity: ≤ 80% RH, non-condensing

Features
The ATA-M2 includes an LCD panel for displaying device status and parameters, ensuring ease of use. It supports real-time monitoring through output current and voltage monitors, which can be connected to an oscilloscope.

Protection and Safety
The amplifier is equipped with multiple protection mechanisms, including over-temperature, over-voltage, short-circuit, and no-load protection. The device will only resume operation after any fault is cleared.

Accessories
The product package includes a power cable, BNC cables, output cable set, USB cable, fuse, user manual, usage guide, product qualification certificate, calibration certificate, and packing list.

Contact Information
For further inquiries, contact Xi'an Aigtek Electronic Technology Co., Ltd. at +86-29-88865020.

Catalog excerpts

Xi'an Aigtek Electronic Technology Co., Ltd. AigtekATA-M2 Power Amplifier • Maximum Output Voltage: 175Vrms • Maximum Continuous Output Power: 200VA • Maximum Pulse Output Power: 500VA, 10%@1S • Over Temperature Protection, Over Voltage Protection, Short Circuit Protection, and No Load Protection The ATA-M2 is an ideal single-channel power amplifier. It delivers a maximum output voltage of 175Vrms, continuous power of 200VA, and pulse power up to 500VA. It is capable of driving 0~100% of both resistive and non-resistive loads. The output impedance is matched with multiple selectable ranges, allowing users to adjust according to specific testing requirements. LCD PANEL DISPLAY The ATA-M2 features an LCD screen that dynamically displays device status and parameters. The user interface is intuitive, clear, and easy to understand, ensuring a user-friendly experience. INPUT Single-ended input with a BNC connector; the input signal's valid value must not exceed 1Vrms. Output Current Monitor: 100mV/A Output Voltage Monitor: 10mV/V The output monitoring port uses a BNC connector and can be directly connected to an oscilloscope for real-time monitoring. OUTPUT The output impedance is matched with multiple selectable voltage ranges. According to testing requirements, the output can be adjusted by setting the desired voltage percentage (0~100%) within the corresponding range. The device is equipped with protection features against over-temperature, over-voltage, short-circuit, and no-load conditions. The LCD panel displays the current protection status, and output can only resume after the fault has been cleared. Note: 1. The valid value of the input signal must not exceed 1Vrms. Adjustments within this limit may be made as needed for actual use. 2.During operation, the device must be used strictly within the specified bandwidth, maximum output voltage, and load limits. Over-range and no-load operation are strictly prohibited.

Open the catalog to page 1