Precision load cell for measuring tension and compressive forces With internal thread for force introduction With ball radius as force introduction With ball radius as force introduction Features • Solid steel housing • Encapsulated version IP65 • Easy installation with metal screws • Unit sensitivity • Specific measuring ranges available Application The load cell X-134 is suitable for force measurement in applications where high accuracies are required. The load cells can be calibrated and supplied with a recognized calibration certificate if required. The sensors are based on proven strain gauge technology and provide a linear signal, proportional to the measured force. The solid steel housing and the sealed construction (IP65) guarantee a trouble-free operation, even under harsh environmental c

Description Measuring Output- Contact Assembly Characteristic Specificati range signal surface in mm ons X-134-20 0 ... 20 kN 4 mV /V 0 104.7 x 34.8 mm 8x screws With internal thread for force Page 3 introduction X-134-50 0 ... 50 kN 4 mV /V 0 104.7 x 34.8 mm 8x screws With internal thread for force Page 3 introduction X-134-100 0 ... 100 kN 4 mV /V 0 120.7 x 53.8 mm 4x screws With ball radius as force Page 4 introduction X-134-200 0 ... 200 kN 4 mV /V 0 120.7 x 53.8 mm 4x screws With ball...

Mechanical dimensions The load cell is delivered without fixing screws. For detailed ordering information see page 2.

Precision load cell X-134-B 0 120.7 x 53.8 mm, Up to 200 kN Mechanical dimensions The load cell is delivered without fixing screws. For detailed ordering information see page 2.

Precision load cell X-134-C 0 138 x 57.2 mm, Up to 500 kN Mechanical dimensions The load cell is delivered without fixing screws. For detailed ordering information see page 2.

Zero point adjustment The zero point adjustment at force sensors with a mV/V-output signal is carried out in the connected strain gauge amplifiers. For X-Sensors two options for zero point adjustment are available: For cyclical and fast load changes, there is a control input to trigger the zero point adjustment from external. For static applications, the zero point adjustment can be carried out onboard by means of DIP-switches and potentiometers. Further information concerning the zero point adjustment can be found in data sheets of the measuring amplifiers listed in the accessories. Definition...