The ideal solution for short distances and small loads The Wyssen small cableway is ideally suited for transporting baggage or building material to remotely situated mountain, club or holidays homes. The maximum cableway length is 100 m. The carriage is very light with 34 kg and its simple and uncomplicated construction makes it very inexpensive. The cable car is suitable for skyline cable diameters of ø up to 9 mm. The drive unit is a small electric winch that works at an operating voltage of 230 V. Operation is simple and uncomplicated with a switch directly on the winch, which can optionally be supplied with radio remote control. In the case of convex terrain, supports with a suspension cable saddle can also be built. Transporting people on the small cableway is strictly prohibited. Small Cableway All prices in this product data sheet are exclusive of VAT. 1a) Drive with chain suspension The especially light drive runs on 2 plastic rollers, different containers can be attached to the 4 chains. The drive can also cross over supports with skyline support saddles. Item No.: Dead weight: - chain suspension including 4 chains and 6 shackles - cable lock suitable for pull cable Item No. 5449-5 1b) Loading bridge The lightly built and robust aluminum carriage is attached to the drive on the four chains. Item no.: Loading beck: Dead weight: Wyssen Seilbahnen AG Tel: +41 33 676 76 74 E-Mail: [email protected] www.wyssen.com

2a) Complete support The support can be inserted into soft ground (meadow) and anchored using guy ropes. Two ground anchors are used for anchoring, which are hammered into the ground. You can also encase the support into concrete. Item No.: Support height: Cable height: - 2x guy ropes ø 8 mm x 12 m (item no. 360.651) - 2x ground anchor (item no. 360.650) - 2x shackle 1/2” (item no. 5445-02) - 8x U-clamp terminals (item no. 5442D08) Suspension cable saddle All listed individual components are available as spare parts. 2b) Suspension saddle The cable saddle is used to hold up the cable and is suspended...

Item No.: Motor: Speed: Max. cable capacity: Max. tension: Weight: 3b) End buffer for end mast The end buffer is mounted on the end mast on the mountain side and is used for automatic stopping when retracting from the drive. The end buffer is strongly recommended when using remote control or when the loading and unloading position is close to the end mast. Item No.: 370.710 Includes: electrical wiring 3c) End buffer on valley side The end buffer on the valley side is used to stop at the exact desired loading position. The end buffer is clamped to the cable (no automatic stop). Item No.: 370.750...

Traction cable to winch electric. The cable is rolled up on the drum. 4c) Pull Cable Item No.: Cable diameter: Cable length: Design: Min. breaking strength: 5) Suspension Cable The Habegger wire rope hoist is used as suspension cable, which can also be tensioned directly using the Habegger wire rope hoist. Item No.: Cable diameter: Cable length: Design: Min. breaking strength: Includes: 370.TS-D8.4X70M 8.4 mm 70 m 6x19+FC galvanized 50 kN (5000 kg) - 4x bow clamps (item no. 5442D08) - 2x shackles 1/2” (item no. 5445-02) - 1x anchor pulley (item no. 36.804) - 1x duplex clamp (item no. 5444D09)...

6c) Round sling 2t - 1m (green) For tensioning the Habegger wire rope hoist at the end mast. Used if the suspension cable is not tensioned directly with the wire rope hoist. Item No.: 5540-02NL01.0 Shackles, slings, rope clips or rolls available as required. Pricing on request 7a) Titan ground anchor The Titan ground anchor is an option for anchoring the suspension cable in compact soil (meadow), instead of end masts. The spikes are buried in the ground using mallets. The anchorage can be removed at any time. Item No.: Includes: Max. tension: Weight: 36.1310A 6x spikes and shackles 5/8" 1'000...

Wyssen Small Cableway System Wyssen Seilbahnen AG Tel: +41 33 676 76 74 E-Mail: [email protected] www.wyssen.com