http://www.wuntronic.com e-mail: [email protected] Mess-, Steuer- und Regelgeräte GmbH Triaxial Accelerometer for ±1g to ±2g Zero g Bias Stability 3 mg, Precision Aligned ±0.15° Precision Aligned ±0.15°, Wide Bandwidth to 2100 Hz Very Low Noise 110 μg/√Hz Model 34201A Features: Zero g Bias Stability 3 mg Precision Aligned ±0.15° Wide Bandwidth to 2100 Hz Very Low Noise 110 μg/√Hz Power Supply +8.5 VDC to +36VDC Small and Rugged 3 Years Warranty Benefits and Advantages Precision The Triaxial Accelerometer 34201A offers precision measurements over the entire -40 to +85°C temperature range with superior bias stability and approximately 100μg measurement resolution. High Accuracy and Linearity over Wide Temperature Range Description: The 3 axial accelerometer 34201A has each mutually orthogonal axis precisely aligned typically within ±0.15 degree of the theoretical ideal. This provides the accuracy required by most measurement applications without any compensation. Critical applications requiring higher accuracy can use the alignment data provided on the optional calibration certificate to compensate for any small residual error. Unregulated +8.5 to +36V DC power is all that is required to power this sensor to measure accelerations on each of three axes. Each axial sensor has been tested over the -40 to +85°C temperature range and has has a nominal full scale output swing of ±2 volts. The zero g output level is nominally +2.5 volts and temperature compensated over the range of -40 to +85°C. Precise values for each axis are available on the included calibration certificate. The voltage output for each axis of the 34201A is directly proportional to the acceleration along that axis. Each DC-coupled output is fully scaled, referenced and temperature compensated over the entire -40 to +85°C temperature range. Our internal temperature compensation routine provides for unrivaled measurement accuracy over varying temperatures. Calibration Certificate Each 34201A is supplied with a calibration certificate listing gain, offset, and on-axis and transverse alignment parameters needed to ensure rapid and efficient system implementation. Self-Test on Digital Command A TTL-compatible self-test input causes a simulated acceleration to be injected into all three sensors to verify channel integrity. Small Size Complete conditioned triaxial accelerometer in less than one cubic inch. Built-In Power Supply Regulation Unregulated DC power from +8.5 to +36 volts is all that is required to measure accelerations on all axes. Suitable for Harsh Environments The 34201A is robust and can be used in harsh environments. The unit will survive 3500g powered and unpowered. 3 years Warranty All accelerometers come with a three-year factory warranty. Copyright© 2009 WUNTRONIC GmbH. All Rights Reserved

Dimensions: Connections T004 Male D-Shell Connector 3 mm x 0,5 mm Thread 3,5 mm [0.138] Deep (6) Mounting Holes on 3 sides Dimensions in inches [mm], identical for each view where Cable to 9-pin male D-Shell connector Range Measurement Full Scale Sensitivity At 25°C, Option R002 Drift TMin to TMax Alignment Deviation from Ideal Axes Zero g Bias Level At 25°C Drift TMin to TMax Order number Conditions/Notes On each axis, Must specifiy via Option Rnnn Precise values on cal certificate Precise values on cal certificate At <1.25°C/min temperature rate of change Precise values on cal certificate degrees...