The GaGe CobraMaxTM family of digitizers features up to CobraMax CompuScope Family Ultra High-Speed Digitizers for the PCI Bus PCI card with up to 4 GS/s sampling per channel, and up to 4 GB of on-board acquisition memory. Combine several CobraMax cards for up to 16 simultaneous channels in a single system. The CobraMax CompuScope family of GaGe ultra high-speed 8-bit digitizers provides the most powerful combination of speed, memory, and bandwidth as well as a wide portfolio of advanced acquisition features. Wireless Communications Military & Aerospace 3 or 4 GS/s maximum sampling rate per channel Manufacturing Test 8 bits vertical resolution Signal Intelligence 256 MS to 4 GS on-board acquisition memory Non-destructive Testing Synthetic instrumentation Full-size, single-slot PCI card Full-featured front-end, with software selection of all signal conditioning settings 32 bits, 66 MHz PCI standard for 200 MB/s transfer to PC memory Ease of integration with Reference Clock In and Clock Out, External Trigger In and Trigger Event Out Programming-free operation with GageScope® oscilloscope software Software Development Kits available for LabVIEW, MATLAB, C/C# and more Radar/Lidar Laser Optics Embedded digitizer Scope replacement

CobraMax CompuScope Simplified Block Diagram Clk Out Clock Control Master Crystal Oscillator Trig Out External Trigger Circuitry Signal Conditioning Front End Auto Calibration Circuitry A/D SAMPLING Resolution: Maximum Sampling Rate: Sampling Rates: ACQUISITION MEMORY Available on-board memory: 256 MS, 512 MS, 1 GS, 2 GS, 4 GS INPUT CHANNELS Number of Inputs: Connector: Input Voltage Ranges: DC Accuracy: Protection: Absolute Maximum Input Voltage (see Note 2): Impedance: Coupling: 1 or 2 (model-dependent) SMA ±50 mV, ±100 mV, ±200 mV, ±500 mV, ±1 V, ±2 V, ±5 V ±1 % (see Note 1) Diode-clamped...

Coupling: Connector: TRIGGER OUT Amplitude: Impedance: Connector: 0 to 1.5 V into 50 Ω load 50 Ω compatible SMA INTERNAL CLOCK Accuracy: signal may be used to synchronize Square Wave 10 MHz ±50 ppm Minimum 200 mV RMS Maximum 500 mV RMS 50 Ω SMA Operating Mode: Number of Cards: Master/Slave: Multiple/Independent: Master/Slave or Multiple Independent 2 to 8 cards Limited only by backplane Note: In contrast to external multi-card synchronization methods, the CobraMax CompuScope’s internal rigid bridge-board Master/Slave architecture provides true simultaneous sampling, triggering and arming of all...

Notes to specifications: 1) DC accuracy is ±1% on all input ranges 2) On the ±5 V Input Range, the maximum input is 8.5 V RMS Voltage 3) Measured using a 10 MHz sine wave with an amplitude of 95% of full scale. No on-board filtering is used. ORDERING INFORMATION Hardware & Upgrades CobraMax Model Max. Single Channel Sampling Rate Max. Dual Channel Sampling Rate Part Number Memory Memory Memory Memory Upgrade: Upgrade: Upgrade: Upgrade: Master Multi-Card Upgrade Slave Multi-Card Upgrade eXpert Signal Averaging Firmware Option Call Factory GageScope® Software GageScope: Lite Edition GageScope:...