http://www.wuntronic.com e-mail: [email protected] Zero g Bias Stability 3 mg Precision Aligned 0.15Ѱ Wide Bandwidth to 2100 Hz Very Low Noise 110 g/Hz Power Supply +8.5 VDC to +36VDC Small and Rugged 3 Years Warranty > Precision > The Triaxial Accelerometer 34201A offers precision measure-ments over the entire -40 to +85C temperature range with supe- rior bias stability and approximately 100g measurement resolu-tion. High Accuracy and Linearity over Wide Temperature Range The voltage output for each axis of the 34201A is directly propor-tional to the acceleration along that axis. Each DC-coupled output is fully scaled, referenced and temperature compensated over the entire -40 to +85аC temperature range. Our internal temperature compensation routine provides for unrivaled measurement accu-racy over varying temperatures. The 3 axial accelerometer 34201A has each mutu-ally orthogonal axis precisely aligned typically within 0.15 degree of the theoretical ideal. This provides the accuracy required by most measurement appli-cations without any compensation. Critical applica-tions requiring higher accuracy can use the align- ment data provided on the optional calibration certifi-cate to compensate for any small residual error. Unregulated +8.5 to +36V DC power is all that is required to power this sensor to measure accelera-tions on each of three axes. Each axial sensor has been tested over the -40 to +85ѰC temperature range and has has a nominal full scale output swing of 2 volts. The zero g output level is nominally +2.5 volts and temperature com- pensated over the range of -40 to +85ѰC. Precise values for each axis are available on the included calibration certificate. > Calibration Certificate Each 34201A is supplied with a calibration certificate listing gain, offset, and on-axis and transverse alignment parameters needed to ensure rapid and efficient system implementation. Self-Test on Digital Command A TTL-compatible self-test input causes a simulated acceleration to be injected into all three sensors to verify channel integrity. Small Size Complete conditioned triaxial accelerometer in less than one cubic inch. Built-In Power Supply Regulation Unregulated DC power from +8.5 to +36 volts is all that is required to measure accelerations on all axes. Suitable for Harsh Environments The 34201A is robust and can be used in harsh environments. The unit will survive 3500g powered and unpowered. 3 years Warranty All accelerometers come with a three-year factory warranty. Copyright 2009 WUNTRONIC GmbH. All Rights Reserved Heppstrasse 30 D - 80995 Mɼnchen Phone +49 89 / 313 30 07 Fax +49 89 / 314 67 06 >

T004 Male D-Shell Connector > Pin Signal Wire 1 2 3 4 5 6 7 8 9 A1+ Signal A2+ +5V Out A3+ T+ Self Test-L +Vs Gnd Brown Red Orange Yellow Green Blue Violet Grey White 3 mm x 0,5 mm Thread 3,5 mm [0.138] Deep (6) Mounting Holes on 3 sides Dimensions in inches [mm], identical for each view where Cable to 9-pin male D-Shell connector Order number R002: 2g R1.5: ѱ1.5g R001: 1g T000: PCB mount T004: 4 ft cable with DB9M Tnnn: Custom length, nnn ft. Two 3 mm x 0.5 mm threaded holes are provided on each of three orthogonal faces for mounting. > Range Measurement Full Scale ѱ2.0 g On each axis, Must...