PRELIMINARY Razor CompuScope 16XX The GaGe RazorTM family of multi-channel digitizers 16-Bit Family of Multi-channel Digitizers for the PCI Bus features up to 4 channels in a single-slot PCI card with up to 200 MS/s sampling per channel, and up to 4 GB of on-board acquisition memory. Combine several Razor cards for up to 32 channels in a single system. The Razor family of 16-bit digitizers represents a new generation of high-speed, high-resolution data acquisition cards from GaGe. Razor digitizers offer many powerful advanced features including: Radar Design and Test Disk Drive Testing 100 or 200 MS/s maximum sampling per channel Manufacturing Test 16 bits vertical resolution Signal Intelligence 128 MS to 2 GS on-board acquisition memory Lidar Systems Full-size, single-slot PCI card Non-Destructive Testing Full-featured front-end, with software control over input ranges, coupling and impedances 32 bits, 66 MHz PCI standard for 200 MB/s transfer to PC memory Ease of integration with External or Reference Clock In and Clock Out, External Trigger In and Trigger Out Programming-free operation with GageScope® oscilloscope software Software Development Kits available for LabVIEW, MATLAB, C/C# Spectroscopy High-Performance Imaging Ultrasound Test

PRELIMINARY Razor CompuScope 16XX Simplified Block Diagram Trig Out CH 1 ADC 1 Auto Calibration Circuitry Signal Conditioning Front End Clk In 10MHz Reference / External Clock Clock Control Master Crystal Oscillator External Trigger Circuitry DC User Offset ± 1xFull Range (above ±5 V is limited to ±2.5 V) Absolute Max Input: ±15 V (50 W), ±75 V (1 MW on all but two lowest Input Ranges, where Max is +/- 25 V) Number of Inputs: 2 or 4 Resolution: 16 bits Dynamic Parameters (see Note 1): CS16X1 Low-Pass Filter Type: Cut-off Frequency: Operation: 3-pole, 1 per channel 25 MHz Individually software-selectable...

PRELIMINARY TRIGGER OUT Impedance: Amplitude: Connector: INTERNAL CLOCK Accuracy: EXTERNAL CLOCK Maximum Frequency: Minimum Frequency: Signal Level: Termination Impedance: Duty Cycle: Connector: Coupling: Maximum Razor sample rate 10 MHz Minimum 1 V RMS Maximum 2 V RMS 50 W 50% ±5% SMA AC EXTERNAL REFERENCE The External Reference timebase is used to synchronize the Internal Sampling Clock Frequency: 10 MHz ±1000 ppm; (software-selectable) Signal Level: Minimum 1 V RMS Maximum 2 V RMS Impedance: 50 W Duty Cycle: 50% ±5% Connector: SMA Coupling: AC CLOCK OUT Maximum Frequency: Minimum Frequency:...

PRELIMINARY Notes to specifications: 1) Dynamic parameter measurements were done by acquiring a high purity 10 MHz sine wave with an amplitude of 95% of the Input Range. These measurements were taken on the +/500 mV Input Range using 50 Ohm termination and DC coupling and the anti-aliasing filter was applied. Dynamic parameter calculations were done from a 16 kiloSample Fourier Spectrum after applying a 7-term Blackman Harris Windowing Function to the time-domain waveform. 2) Measured at 100 MS/s in the ±500 mV range with 50 W input impedance with an amplitude of 95% of full scale. 3) Measured...