Catalog excerpts
©»»»»»» WPT Low Inertia (LI) Clutches are well suited for high cycle applications, such as steel shears and stamping presses. The Low Inertia design reduces the rotational mass during starts and stops, allowing for increased cycles per minute and reduced deceleration times. This advantage also leads to reduced heat generation during dynamic braking conditions. WPT’s Low Inertia Clutches are available in 1, 2, or 3 plate construction with diameters ranging from 6 through 60 inches. • High cycle life • Predictable preventative maintenance • Hydraulic actuation available • Slotted, solid and ventilated center plates available • See Power Performance upgrade on page 12 Consult WPT Application Engineering for application assistance, service factors, specifications, and detailed drawings/3D models. *Contact WPT for larger bore sizes. Listed bore sizes are for square key. **Dynamic (slipping) Torque is 75% of the Static Torque.
Open the catalog to page 1LI Clutch Dimension Model
Open the catalog to page 2All WPT Power Corporation catalogs and technical brochures
-
Mechanical Power Take-Off
4 Pages
-
Steel Water Cooled Brake
2 Pages
-
Caliper Disc Brake
1 Pages
-
Power Grip High Speed Clutch
3 Pages
-
Power Grip & Power PO Clutches
16 Pages
-
Engine Driven Products
24 Pages
-
Winches and Hoists
24 Pages
-
WPT LowIInertia
12 Pages
-
Caliper Brakes
4 Pages
-
Water Cooled Brakes
12 Pages
-
Low Inertia Clutches and Brakes
12 Pages