EN110 Industrial Modbus LoRa Converter EN110 is the new private LoRa converter to replace traditional serial cable with wireless Lora at the device end for kilometer level wireless coverage. For the data transmission, EN110 supports Modbus Master-Slave mode with 1 master to 40 slaves polling within 1 minute. EN110 is a convenient LoRa end node converter to upgrade the Modbus communication in factory automation applications. LoRa Features & Benefits Long Range Wireless Communication • Kilometer level wireless communication • Excellent penetration, even in basement • Communication by broadcast, no need pairing • Small architecture, no gateway & network server required • TX power up to 20dBm, RX sensitivity down to -137dBm • Max packet size 255 bytes for Modbus data Plug and Use, Minimized Configuration • T ransparent replacement of RS485 cabling • 1x RS232+ 1x RS485 for serial communication • Easy frequency selection through DIP switch • Easy devices grouping through broadcast domains • Configuration utility for advance settings • Support 5~24 DC input & USB 5V Broadcast domain grouping ThingsMaster LoRa MQTT Smart city LoRa communication www.womaster.eu 1. |

Reset Button Wall Mount Clip ・System Reboot ・Also used for DIN rail mounting with bracket (DIN bracket not Included) Micro USB Power ・1 x Micro USB 5V power input Integrated Connector ・1 x 7-pin terminal block 2 Pins for power input(5~24V) 3 Pins for RS232 2 Pins for RS485 DIP Switch ・1 x Terminal Resistance Setting ・1 x Setting Mode ・2 x Frequency Setting (913.5/921.5/9

Interface System LED 1 x Power: Red On 1 x Tx : Yellow blinking when transmitting 1 x Rx : Blue blinking when receiving Reset System reboot SMA Connector 1 x SMA Female for LoRa DIP Switch 1: Terminal Resistance Setting (1200) 2: Configuration Mode (Frequency configuration or pre-defined frequency) 3/4: Frequency Selection (913.5/921.5/923.5 MHz) Power Input, Serial LoRa 1 x Micro USB Type B for 5V Power Input (alternative) 1 x 7-Pin Removable Terminal Block Connector 2 Pin for Power Input 3 Pin for RS232 2 Pin for RS485 *Do not use USB and DC power at the same time Data Rate Frequency Accuracy...