Gateway multibus Interface for the direct connection of two different worlds. The device consists of a plastic housing with 6 modules, fitted with a plug-type connection (output). It has been conceived for DIN35 rail mounting. The whole range of Belimo MFT/MFT2 actuators, operated by MP-Bus, can be individually connected to this interface coupler and be integrated to the KNX network. The KNX interface is able to support up to 8 MP actuators - e.g. flap drives, valve drives, regulation ball valve drives or flow rate controllers - intended for building automation. During commissioning the KNX Gateway is configurated with ETS. The requested drive channel is selected and parametrised for the needed drive type. Status indicators and push-buttons for programming the address- and test-functions are located on the front side of the device. There is also a plug intended for the Belimo hand-held parameter assignment device. Actual and setpoint values, status of the drive and also the values of passive or active sensors connected to the drive are transmitted via KNX.

Building automation Gateway to flat cable ecobus combi 5G2.5mm2+2xl.5mm2 and multibus 4x1.5mm2 Example of application: Appliances with volumetric flow controllers (Master/Slave- or parallel operation) F ■ iKKrf DDfri rota Belimo devices Number of control e i re u its NMV-D2M (volumetric flow controller VAV} 4 control circuits can be realized by means of 1 UK24EIB module Room control unit No. 495&1/X (optional) Window contact (oplonai) Appliances with volumetric flow controllers with active room temperature sensor (0°C ... 50°C / 0 ...10VDC). Window contact and KNX room control unit optional....

Gateway multibus KNX 5.3.60 Type UK24EIB -wiring performed by means of push-/screw terminals -actuators can be controlled digitally through the UK24EIB over an MP-Bus system and provide a feedback signal of their actual operating position Gateway multibus KNX Type UK24EIB No. 49667 405 990 207 Technical data Weight 0.3kg Dimensions Protection class Rated voltage Rated voltage range Power input 105x90x58mm III (safety low voltage) 24VAC, 50/60Hz / 24VDC 19.2 ... 28.8VAC, 21.6 ... 28.8VDC 2VA (without MFT2 actuators connected) Power consumption 1W Mounting on DIN rail 35mm Connections KNX: Supply:...