Catalogs >
Wirtgen >
Electric cold milling machine W 350 E

Electric cold milling machine W 350 E
6Pages

Catalog excerpts

Electric cold milling machine W 350 E - 1

The small cold milling machine with electric drive Electric cold milling machine W 350 E

Electric cold milling machine W 350 E - 2

Exhaust-free rehabilitation of indoor pavements with the W 350 E Economical surface rehabilitation inside buildings Narrow workshop doors and kitchen corridors: no problem for the slim W 350 E Uniform milling of a kitchen floor at a milling depth of 4 cm Contractors are often called upon to rehabilitate contaminated pavements in such difficult areas as food-processing plants or chemical factories. Milling is usually the simplest solution in such cases, but the stringent requirements imposed with regard to the quality of the air in such areas often make continuous operation of diesel-powered...

Open the catalog to page 2

Electric cold milling machine W 350 E - 3

Electric cold milling machine W 350 E: the advantages at a glance Highly manoeuvrable and compact The right-hand rear wheel can be swivelled inwards to allow the machine to mill right up to walls and other obstacles. A power generator ensures that the machine can be transferred without difficulty from the transport vehicle to the job site. Thanks to its slim width of only 1 m, the machine easily passes through the hall doors. Powerful, multi-purpose machine The milling drum is driven by a 3-phase motor with a power rating of 22 kW. The hydraulic pumps and thus the front wheel are driven by...

Open the catalog to page 3

Electric cold milling machine W 350 E - 4

3 // 4 The milling depth of up to 10 cm meets the requirements for rehabilitating indoor pavements. Various special milling drums allow the machine to be used to mill slits and to remove thin layers, as well as for rehabilitation of large areas. Clean, efficient operation An optional connection for a dust extractor device can prevent the development of dust in the building. Cables of various lengths allow the operator sufficient freedom to work without interruption. Cable-free transfer to the job location due to removable power generator Good access to engines and all points of maintenance

Open the catalog to page 4

Electric cold milling machine W 350 E - 5

2 // 5 Broad range of milling drums allows large range of applications Fine milling drum Standard milling drum Milling ring Saw blade On the road to success with the highly developed Wirtgen cutting technology Precise milling flush to the edge The right milling drum for any given requirement Milling drums for all customer specific requirements The W 350 E is equipped with a standard milling drum of 350 mm width (optional 500 mm). For the milling of thin pavement layers, the standard milling drum can be exchanged quickly and easily against optional fine milling drums. For special...

Open the catalog to page 5

Electric cold milling machine W 350 E - 6

Illustrations are without obligation. Subject to technical changes. Performance data depend on operational conditions. No. 05-12 EN-03/06 © by Wirtgen GmbH 2006. Printed in Germany Wirtgen GmbH Hohner Straße 2 · 53578 Windhagen · Germany Phone: +49 (0) 26 45 / 131-0 · Fax: +49 (0) 26 45 / 131-242 Internet: www.wirtgen.com · E-Mail: info@wirtgen.com

Open the catalog to page 6