Catalogs >
WinSystems, Inc. >
ISM-DC-AT512-P

ISM-DC-AT512-P
2Pages

Catalog excerpts

ISM-DC-AT512-P Small Form Factor +5V and +12V DC/DC Power Supply Features • Wide input range: 10V to 50VDC • Voltage output: +5V and +12V • No minimum load required for regulation • Outputs with short circuit and overload protection • LEDs provide visual status of power • Two Phoenix® terminal blocks for output power • High efficiency design • Fast transient response • No fan or heat sink required • -40° to +85°C operation supported • Small size: 3.6 x 3.8 inches (90 x 96mm) • PC/104 and PC/104-Plus version with ATX support available • Custom OEM configurations available • RoHS compliant Output Power WinSystems' ISM-DC-AT512-P is a dual output, DC/DC power supply designed for small form factor embedded systems. It features a very wide voltage input range from 10 to 50 volts DC. This allows the unit to operate with 12, 24, or 48 volt battery or distributed DC power systems. It opens up a wide array of applications including transportation, Mil/COTS, security, solar-powered, and telecommunications. The design has fast transient time and low ripple on the outputs. Each output is short circuit protected and current limited. A minimum load is not needed to bring the supply into regulation. When power is applied to the board, two LEDs will illuminate providing a visual status that power is available for the +5V and +12V outputs. If one of these LEDs is not lit or is pulsing, then the respective supply voltage is not in regulation. A pulsating LED is an indication that the respective converter is in current limit. The ISM-DC-AT512-P is designed to operate at extended temperatures without forced air cooling or heatsink. This maximizes reliability and reduces weight for the module and the system it powers. WinSystems | 715 Stadium Drive, Arlington, TX 76011 USA | Tel 817-274-7553 | Info@WinSystems.com | www.WinSystems.com

Open the catalog to page 1

The board is populated with low-profile, soldered down, surface mount components which keep the overall height of the board low. Input Connector - A Phoenix Combicon connector allows power to be easily and securely brought to the board with a quick way to remove it if necessary. The mating connector is shipped with each board. Output Connector - There are two, four-pin Phoenix Contact terminal blocks at the edge of the board to connect to the output power. Fanless - No fans or heatsinks are required to meet the extended operating temperature range of -40° to +85°C. Other Standard...

Open the catalog to page 2

ISM-DC-AT512-P 2Pages

Catalog excerpts

All WinSystems catalogs and technical brochures

ISM-DC-AT512-P
2Pages