Safe Transport of Concrete Parts via High Clamping Force Adjustable Suspension Ring for Balancing the Center of Gravity Subject to alteration I 12.2016

Flat Grab FGS with Adjustable Suspension Ring for the Safe Handling of Concrete Parts. The Flat Grab FGS was developed for handling rough stones and concrete parts with parallel surfaces. The high clamping force guarantees safe handling. One clamping jaw is adjustable. The narrow construction of the second clamping jaw is welded to one end of the beam. This narrow construction enables the grasping, tensioning and the safe upright setting of horizontally positioned concrete parts. Due to the adjustable suspension ring, e.g. L-shaped stones can be put into an upright position. The FGS is equipped...

Flat Grab FG / FGB for the Safe Handling of Wide Loads. The Flat Grab FG was developed for the handling of rough stones and concrete parts with parallel surfaces. High clamping force guarantees safe handling. The complete clamping range of both clamping jaws is adjustable. Due to the adjustable suspension ring, parts with an eccentric center of gravity can also be held in a horizontal position. The FG is equipped with exchangeable rubber coatings. The Flat Grab FG can be used near to the ground with any lifting equipment. For picking up the load, a bolt is pulled which snaps in by itself when...

Plate Grab for the Safe Handling of Horizontally Positioned Plates The Plate Grab PG was developed for handling rough plates with parallel surfaces. The high lever transmission guarantees high clamping force. By turning the clamping jaws, parts can also be gripped from the inside. The PG is equipped with exchangeable rubber coatings. The equipment is orange in colour, RAL 2000. Inside clamping range Outside clamping range Carrying Capacity Outside Clamping Range Inside Clamping Range Weight approx. Special Constructions The Accident Prevention Regulation VBG 9a “Load-Handling Equipment for Hoisting...