UNITOR INSTRUCTION MANUAL

Product catalog summary

Introduction
This manual provides instructions for the 60:1 grease pump designed for 20kg and 50kg drums, featuring a unique air motor for quiet and efficient operation. It is suitable for dispensing greases with a viscosity up to NLGI 3 and includes a 2” bung adapter for drum mounting.

General Specifications

Pressure Ratio: 60:1
Maximum Air Pressure: 10 bar (145 psi)
Delivery Rate: 1100g/min at 7 bar air pressure
Air Inlet Connection: 1/4” BSP
Grease Outlet: 3/8” BSP
Noise Level: 84 dB at 7 bar

Safety Precautions

Do not exceed maximum pressure limits.
Ensure compatibility of all components with system pressure.
Use only for grease up to NLGI 3; not suitable for water-based or explosive fluids.
Regularly inspect for leaks and wear, especially hoses.
Disconnect air supply and relieve pressure before maintenance.

Installation Instructions

Remove protective packing and install the drum adapter.
Position the pump vertically in the drum, ensuring clearance from the bottom.
Connect the grease outlet hose and air quick coupling nipple.
Install an air regulator if system pressure exceeds pump working pressure.

Maintenance Guidelines

Disconnect air motor and relieve system pressure before servicing.
Regularly check air filter, lubricator, and connections for leaks or damage.
Keep equipment clean to prevent contamination.

Troubleshooting

Pump not operating: Check air pressure, motor, and filters.
Pump running but not delivering: Check grease level and seals.
Grease leakage: Inspect and replace worn packings.

Declaration of Conformity
The pump complies with relevant standards and EC Directive (2006/42/EEC).

Catalog excerpts

Wilhelmsen Ships Service OPTIMISING PERFORMANCE UNITOR INSTRUCTION MANUAL60:1 GREASE PUMP FOR 20KG/50KG DRUMS W/ 4M HOSE AND GUN FOR 20KG DRUM FOR 50KG DRUM MARINE PRODUCTS MARINE CHEMICALS SAFETY MARITIME LOGISTICS SHIPS AGENCY

Open the catalog to page 1

INSTRUCTION MANUAL UIIITOR 60:1 GREASE PUMP FOR 20KG/50KG DRUMS W/ 4M HOSE AND GUN Thank you for choosing a high quality pump. The 60:1 grease pump features our unique air motor for quiet and quick serviceability. Recommended for mobile units and piped installations of moderate length, to dispense greases with a viscosity up to NLGI 3. Included with the pump is a 2” bung adapter for mounting the pump on a drum cover. • A pump's ability to deliver fluid is based on the pressure (bar/ psi) and quantity of air supplied to the air- motor and the amount of material discharge (back) pressure to be...

Open the catalog to page 2

Wilhelmsen Ships Service OPTIMISING PERFORMANCE INSTRUCTION MANUAL UIIITOR 60:1 GREASE PUMP FOR 20KG/50KG DRUMS W/ 4M HOSE AND GUN • If a lubricator is installed it should always be filled with air tool oil or similar. Mineral based motor oil, SaE 10, can also be used. Synthetic oil or other oils must NOT be used. • Possible leakage in the connections and couplers. • All connected hoses for wear or possible damage. Keep the lubricant and the equipment clean and free from dirt. The dirt will otherwise enter the pump and contaminate the grease and possibly damage the pump. Put the pump in into...

Open the catalog to page 3

Wilhelmsen Ships Service OPTIMISING PERFORMANCE Wilhelmsen Ships Service Postal address PO Box 33 N-1324 Lysaker Norway T (+47) 67584550 F (+47) 67584570 Visiting address Strandveien 20 N-1366 Lysaker Norway Part of Wilhelmsen Maritime Services, a Wilh. Wilhelmsen group company MARINE PRODUCTS MARINE CHEMICALS SAFETY MARITIME LOGISTICS SHIPS AGENCY

Open the catalog to page 4